[PATCH v3 2/7] mmc: sdhci_am654: Write ITAPDLY for DDR52 timing

[Judith Mendez]

For DDR52 timing, DLL is enabled but tuning is not carried
out, therefore the ITAPDLY value in PHY CTRL 4 register is
not correct. Fix this by writing ITAPDLY after enabling DLL.

Fixes: a161c45f2979 ("mmc: sdhci_am654: Enable DLL only for some speed modes")
Reviewed-by: Andrew Davis <afd@xxxxxx>
Signed-off-by: Judith Mendez <jm@xxxxxx>
---
Changelog:
v2->v3:
- no change
---
 drivers/mmc/host/sdhci_am654.c | 1 +
 1 file changed, 1 insertion(+)

diff --git a/drivers/mmc/host/sdhci_am654.c b/drivers/mmc/host/sdhci_am654.c
index d11b0d769e6c..896d4660b535 100644
--- a/drivers/mmc/host/sdhci_am654.c
+++ b/drivers/mmc/host/sdhci_am654.c
@@ -300,6 +300,7 @@ static void sdhci_am654_set_clock(struct sdhci_host *host, unsigned int clock)
 	if (timing > MMC_TIMING_UHS_SDR25 && clock >= CLOCK_TOO_SLOW_HZ) {
 		sdhci_am654_setup_dll(host, clock);
 		sdhci_am654->dll_enable = true;
+		sdhci_am654_write_itapdly(sdhci_am654, sdhci_am654->itap_del_sel[timing]);
 	} else {
 		sdhci_am654_setup_delay_chain(sdhci_am654, timing);
 	}
-- 
2.43.2