Re: [PATCH v2] spi: mt7621: allow GPIO chip select lines
From: AngeloGioacchino Del Regno
Date: Mon Mar 18 2024 - 06:16:27 EST
Il 16/03/24 02:03, Justin Swartz ha scritto:
Extract a magic number, from mt7621_spi_probe(), used to
declare the number of chip select lines (which co-incides
with the native chip select count of 2) to a macro.
Use the newly defined MT7621_NATIVE_CS_COUNT macro to
instead populate both the spi_controller's max_native_cs
and num_chipselect members.
Declare that the spi_controller should use_gpio_descriptors
if present in the device properties (such as those declared
in the cs-gpio property of a "ralink,mt7621-spi" compatible
device-tree node) so that the SPI core will recalculcate
num_chipselect to account for the GPIO descriptors that
it should have populated in the cs_gpiod array member.
Remove the assignment of mt7621_spi_transfer_one_message()
to the spi_controller's transfer_one_message hook.
Refactor the mt7621_spi_transfer_one_message() logic into
mt7621_spi_prepare_message() and mt7621_spi_transfer_one()
and assign both to the spi_controller's prepare_message
and transfer_one hooks respectively.
Migrate the call mt7621_spi_transfer_one_message() made to
mt7621_spi_flush() just before chip select deactivation,
to the end of mt7621_spi_write_half_duplex() to ensure
that any pending data is shifted out of MOSI before the SPI
core deactivates the chip select line.
As chip select activation is now taken care of by the SPI
core, due to the use of the transfer_one hook instead of
transfer_one_message, the calls to mt7621_spi_set_cs()
from mt7621_spi_transfer_one_message() have fallen away.
And although the SPI core will handle activation for GPIO
chip select lines behind the scenes, it requires a callback
to allow the driver to perform controller-specific
operations to control its native chip select lines.
Rename mt7621_spi_set_cs() to mt7621_spi_set_native_cs()
and make sure that it takes into account the activation
polarity of the chip select line it's acting upon, as the
passed enable parameter represents the desired line level
and not the desired activation state, and then assign
mt7621_set_cs() to the spi_controller's set_cs hook.
Signed-off-by: Justin Swartz <justin.swartz@xxxxxxxxxxxxxxxx>
Reviewed-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@xxxxxxxxxxxxx>