Re: [PATCH 1/2] arm64: dts: mediatek: mt7622: set PHY address of MT7531 switch to 0x1f

[Florian Fainelli]

On 3/18/24 08:26, Arınç ÜNAL wrote:
> On 18.03.2024 16:02, Florian Fainelli wrote:
> > > > Can we call it a pseudo PHY to use a similar terminology as what is 
> > > > done through drivers/net/dsa/{bcm_sf2,b53}*?
> > > >
> > > > This is not a real PHY as in it has no actual transceiver/digital 
> > > > signal processing logic, this is a piece of logic that snoops for 
> > > > MDIO transactions at that specific address and lets you access the 
> > > > switch's internal register as if it was a MDIO device.
> > >
> > > I can get behind calling the switch a psuedo-PHY in the context of MDIO.
> > > However, as described on "22.2.4.5.5 PHYAD (PHY Address)" of "22.2.4.5
> > > Management frame structure" of the active standard IEEE Std 802.3™‐2022,
> > > the field is called "PHY Address". The patch log doesn't give an 
> > > identifier
> > > as to what a switch is in the context of MDIO. Only that it listens on a
> > > certain PHY address which the term complies with IEEE Std 802.3™‐2022.
> > >
> > > So I don't see an improvement to be made on the patch log. Feel free to
> > > elaborate further.
> >
> > I would just s/PHY/MDIO bus address/ since that is simply more 
> > generic, but if it is not written as-is in the spec, then I won't 
> > fight it much more than I already did.
>
> I'm not sure what you're referring to by spec. Are you asking how specific
> the name of the PHYAD field is described on the standard?

Spec = IEEE Std 802.3-2022 standard, aka the document you are quoting.
--
Florian