Re: [PATCH v6 04/13] crypto: ecdsa - Extend res.x mod n calculation for NIST P521

[Jarkko Sakkinen]

On Tue Mar 12, 2024 at 8:36 PM EET, Stefan Berger wrote:
> From: Stefan Berger <stefanb@xxxxxxxxxxxxx>
>
> res.x has been calculated by ecc_point_mult_shamir, which uses
> 'mod curve_prime'. The curve_prime 'p' is typically larger than the
> curve_order 'n' and therefore it is possible that p > res.x >= n.

The first sentence is an incomplete sentence. A lot of cross-referencing
from e.g. elixir is required to "decipher" this commit message :-)

I do get that math here is complicated but for that matter each commit
message should be written with care, minimizing the require cross-
referencing.

These commit messages are adding extra layer of salt.

>
> If res.x >= n then res.x mod n can be calculated by iteratively sub-
> tracting n from res.x until n > res.x. For NIST P192/256/384 this can be
> done in a single subtraction. This can also be done in a single
> subtraction for NIST P521.
>
> The mathematical reason why a single subtraction is sufficient is
> due to the values of 'p' and 'n' of the NIST curves where the following
> holds true:
>
>    note: max(res.x) = p - 1
>
>    max(res.x) - n < n
>        p - 1  - n < n
>        p - 1      < 2n  => true for the NIST curves
>
> Signed-off-by: Stefan Berger <stefanb@xxxxxxxxxxxxx>
> Tested-by: Lukas Wunner <lukas@xxxxxxxxx>

What was there to test in this anyway? I see only comment change below.

> ---
>  crypto/ecdsa.c | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/crypto/ecdsa.c b/crypto/ecdsa.c
> index 64e1e69d53ba..1814f009f971 100644
> --- a/crypto/ecdsa.c
> +++ b/crypto/ecdsa.c
> @@ -122,7 +122,7 @@ static int _ecdsa_verify(struct ecc_ctx *ctx, const u64 *hash, const u64 *r, con
>  
>  	/* res.x = res.x mod n (if res.x > order) */
>  	if (unlikely(vli_cmp(res.x, curve->n, ndigits) == 1))
> -		/* faster alternative for NIST p384, p256 & p192 */
> +		/* faster alternative for NIST p521, p384, p256 & p192 */
>  		vli_sub(res.x, res.x, curve->n, ndigits);
>  
>  	if (!vli_cmp(res.x, r, ndigits))


BR, Jarkko