[PATCH v3 0/4] NXP S32G3 SoC initial bring-up

[Wadim Mueller]

This series brings up initial support for the NXP S32G3 SoC,
used on the S32G-VNP-RDB3 board [1].

The following features are supported in this initial port:

  * Devicetree for the S32G-VNP-RDB3 
  * UART (fsl-linflexuart) with earlycon support
  * SDHC: fsl-imx-esdhc (SD/eMMC)

== Changes since v2 ==:

  * split each dt schema doc change into a seperate patch
  * removed unnedeed IRQ from SCMI node
  * add mmc bus-width to S32G-VNP-RDB3 board dts file
  * fixed comments in arm-v8 timer interrupt mappings
 

[1] https://www.nxp.com/design/design-center/designs/s32g3-vehicle-networking-reference-design:S32G-VNP-RDB3

Wadim Mueller (4):
  dt-bindings: arm: fsl: Document NXP S32G3 board
  dt-bindings: serial: fsl-linflexuart: add compatible for S32G3
  dt-bindings: mmc: fsl-imx-esdhc: add NXP S32G3 support
  arm64: dts: S32G3: Introduce device tree for S32G-VNP-RDB3

 .../devicetree/bindings/arm/fsl.yaml          |   6 +
 .../bindings/mmc/fsl-imx-esdhc.yaml           |   4 +
 .../bindings/serial/fsl,s32-linflexuart.yaml  |   3 +
 arch/arm64/boot/dts/freescale/Makefile        |   1 +
 arch/arm64/boot/dts/freescale/s32g3.dtsi      | 237 ++++++++++++++++++
 .../boot/dts/freescale/s32g399a-rdb3.dts      |  45 ++++
 6 files changed, 296 insertions(+)
 create mode 100644 arch/arm64/boot/dts/freescale/s32g3.dtsi
 create mode 100644 arch/arm64/boot/dts/freescale/s32g399a-rdb3.dts

-- 
2.25.1