Re: [PATCH 2/2] arm64: dts: add description for solidrun cn9130 som and clearfog boards

[Josua Mayer]

Am 22.03.24 um 16:38 schrieb Josua Mayer:
> For the discrete PHYs, the generic LED code can make use of the
> hardware offload support to read back the hardware configuration and
> configure itself to match. The switch code is missing hardware offload
> at the moment. So it cannot read back the current
> configuration. However, it is simple code to add, and the discrete
> code is a good example to follow.
I have prototyped this on top of your patch-set, supporting offload
for a single mode.
It works as explained by you - first after boot-up the LEDs
are executing their default function autonomously.

When I set trigger netdev, I can see offloaded property is 1,
and when I enable extra bits offload turns off.


For Clearfog Base I have added the requested LED descriptions,
it should be ready now.

The Pro version I could
1) submit new version with only phy leds
2) wait (not preferred)
3) submit new version with an separate patch adding switch leds
(can hold of ack on it till the fait of your patch-set becomes clear)