Re: [PATCH 1/2] V2 arm64: dts: qcom: Add support for Samsung Galaxy Z Fold5

[Konrad Dybcio]

On 29.03.2024 12:08 AM, Alexandru Marc Serdeliuc via B4 Relay wrote:
> From: Alexandru Marc Serdeliuc <serdeliuk@xxxxxxxxx>
> 
> Add support for Samsung Galaxy Z Fold5 (q5q) foldable phone
> 
> Currently working features:
> - Framebuffer
> - UFS
> - i2c
> - Buttons
> 
> Signed-off-by: Alexandru Marc Serdeliuc <serdeliuk@xxxxxxxxx>
> ---

Your commit title now includes "V2". Move it inside the square braces the
next time around, so it's like [PATCH v3 1/2]. With b4, this should be done
automagically, though..

[...]

> +/ {
> +	model = "Samsung Galaxy Z Fold5";
> +	compatible = "samsung,q5q", "qcom,sm8550";
> +	#address-cells = <0x02>;
> +	#size-cells = <0x02>;

These two can go

[...]

> +	reserved-memory {
> +		/*
> +		 * The bootloader will only keep display hardware enabled
> +		 * if this memory region is named exactly 'splash_region'
> +		 */

Ouch.

[...]

> +		vreg_l15b_1p8: ldo15 {
> +			regulator-name = "vreg_l15b_1p8";
> +			regulator-min-microvolt = <1800000>;
> +			regulator-max-microvolt = <1800000>;
> +			regulator-initial-mode = <RPMH_REGULATOR_MODE_HPM>;
> +			regulator-allow-set-load;
> +			regulator-allowed-modes = <RPMH_REGULATOR_MODE_LPM
> +						   RPMH_REGULATOR_MODE_HPM>;
> +			regulator-always-on;

Any particular reason as to why?

[...]

> +&remoteproc_adsp {
> +	firmware-name = "qcom/sm8550/adsp.mbn",
> +			"qcom/sm8550/adsp_dtb.mbn";
> +	status = "okay";
> +};
> +
> +&remoteproc_cdsp {
> +	firmware-name = "qcom/sm8550/cdsp.mbn",
> +			"qcom/sm8550/cdsp_dtb.mbn";
> +	status = "okay";
> +};
> +
> +&remoteproc_mpss {
> +	firmware-name = "qcom/sm8550/modem.mbn",
> +			"qcom/sm8550/modem_dtb.mbn";
> +	status = "okay";

Unless you stole one from the factory, these firmwares will not
load on your phone..

> +};
> +
> +&sleep_clk {
> +	clock-frequency = <32000>;
> +};
> +
> +&tlmm {
> +	gpio-reserved-ranges = <36 4>, <50 2>;

Would you have an idea what these GPIOs are used for?

Konrad