Re: [PATCH v2] x86/boot/64: Clear CR4.PGE to disable global 1:1 mappings

[Ingo Molnar]

* Ard Biesheuvel <ardb+git@xxxxxxxxxx> wrote:

> From: Ard Biesheuvel <ardb@xxxxxxxxxx>
> 
> The early 64-bit boot code must be entered with a 1:1 mapping of the
> bootable image, but it cannot operate without a 1:1 mapping of all the
> assets in memory that it accesses, and therefore, it creates such
> mappings for all known assets upfront, and additional ones on demand
> when a page fault happens on a memory address.
> 
> These mappings are created with the global bit G set, as the flags used
> to create page table descriptors are based on __PAGE_KERNEL_LARGE_EXEC
> defined by the core kernel, even though the context where these mappings
> are used is very different.
> 
> This means that the TLB maintenance carried out by the decompressor is
> not sufficient if it is entered with CR4.PGE enabled, which has been
> observed to happen with the stage0 bootloader of project Oak. While this
> is a dubious practice if no global mappings are being used to begin
> with, the decompressor is clearly at fault here for creating global
> mappings and not performing the appropriate TLB maintenance.
> 
> Since commit
> 
>   f97b67a773cd84b ("x86/decompressor: Only call the trampoline when changing paging levels")
> 
> CR4 is no longer modified by the decompressor if no change in the number
> of paging levels is needed. Before that, CR4 would always be set to a
> consistent value with PGE cleared.
> 
> So let's reinstate a simplified version of the original logic to put CR4
> into a known state, and preserve the PAE, MCE and LA57 bits, none of
> which can be modified freely at this point (PAE and LA57 cannot be
> changed while running in long mode, and MCE cannot be cleared when
> running under some hypervisors)
> 
> Cc: Conrad Grobler <grobler@xxxxxxxxxx>
> Cc: Kevin Loughlin <kevinloughlin@xxxxxxxxxx>
> Fixes: f97b67a773cd84b ("x86/decompressor: Only call the trampoline when ...")
> Signed-off-by: Ard Biesheuvel <ardb@xxxxxxxxxx>
> ---
> v2: Bring back the original logic rather than only clearing PGE. Note
>     that this means that the load of CR4 cannot be elided since MCE and
>     LA57 cannot be set unconditionally.
> 
>  arch/x86/boot/compressed/head_64.S | 5 +++++
>  1 file changed, 5 insertions(+)
> 
> diff --git a/arch/x86/boot/compressed/head_64.S b/arch/x86/boot/compressed/head_64.S
> index bf4a10a5794f..d0f2c591f730 100644
> --- a/arch/x86/boot/compressed/head_64.S
> +++ b/arch/x86/boot/compressed/head_64.S
> @@ -398,6 +398,11 @@ SYM_CODE_START(startup_64)
>  	call	sev_enable
>  #endif
>  
> +	/* Preserve only the CR4 bits that must be preserved, and clear the rest */
> +	movq	%cr4, %rax
> +	andl	$(X86_CR4_PAE | X86_CR4_MCE | X86_CR4_LA57), %eax
> +	movq	%rax, %cr4

Yeah, this is still better IMO than the original patch.

Note that you reused the original title, which isn't entirely accurate 
anymore:

   x86/boot/64: Clear CR4.PGE to disable global 1:1 mappings

I updated it to:

   x86/boot/64: Clear most of CR4 in startup_64(), except PAE, MCE and LA57

Thanks,

	Ingo