[PATCH v2 0/2] pinctrl: scmi: support i.MX95 OEM extensions

[Peng Fan (OSS)]

ARM SCMI v3.2 Table 24 Pin Configuration Type and Enumerations:
'192 -255 OEM specific units'.

i.MX95 System Manager FW supports SCMI PINCTRL protocol, but uses
OEM Pin Configuration type, so extend the driver to support custom
params.

The node will be as below:
pinctrl_usdhc1: usdhc1-pins {
	sd1cmd {  ==> this is needed, so there is a patterProperties in nxp,imx95-scmi-pinctrl.yaml
		pins = "sd1cmd";
		nxp,func-id = <0>;
		nxp,pin-conf = <0x138e>;
	};
	sd1data {
		pins = "sd1data";
		nxp,func-id = <0>;
		nxp,pin-conf = <0x138e>;
	};
};

This patchset depends on [1].

[1] https://lore.kernel.org/all/20240418-pinctrl-scmi-v11-0-499dca9864a7@xxxxxxx/

Signed-off-by: Peng Fan <peng.fan@xxxxxxx>
---
Changes in v2:
- Rename nxp,imx95-pinctrl.yaml  to nxp,imx95-scmi-pinctrl.yaml and move
  to firmware
- Merged patch [1,2]/3 v1 into patch 1/2 v2.
- nxp,imx95-scmi-pinctrl.yaml only has patterProperties for subnode
  The pinctrl will be as below for i.MX95.
	pinctrl_usdhc1: usdhc1-pins {
		sd1cmd {
			pins = "sd1cmd";
			nxp,func-id = <0>;
			nxp,pin-conf = <0x138e>;
		};
		sd1data {
			pins = "sd1data";
			nxp,func-id = <0>;
			nxp,pin-conf = <0x138e>;
		};
	};
- Add pins enum, correct description.
- Link to v1: https://lore.kernel.org/r/20240412-pinctrl-scmi-oem-v1-v1-0-704f242544c1@xxxxxxx

---
Peng Fan (2):
      dt-bindings: firmware: arm,scmi: Add properties for i.MX95 Pinctrl OEM extensions
      pinctrl: scmi: support i.MX OEM pin configuration type

 .../devicetree/bindings/firmware/arm,scmi.yaml     |  9 ++-
 .../bindings/firmware/nxp,imx95-scmi-pinctrl.yaml  | 66 ++++++++++++++++++++++
 drivers/pinctrl/pinctrl-scmi.c                     | 23 ++++++++
 drivers/pinctrl/pinctrl-scmi.h                     | 15 +++++
 4 files changed, 110 insertions(+), 3 deletions(-)
---
base-commit: eb2d3938aa00d2ef504176b77db1735b68763652
change-id: 20240412-pinctrl-scmi-oem-v1-494ca2ab1480

Best regards,
-- 
Peng Fan <peng.fan@xxxxxxx>