Re: [PATCH v3 3/9] PCI: endpoint: Rename BME to Bus Master Enable

[Bjorn Helgaas]

On Fri, Apr 19, 2024 at 03:08:47PM +0530, Manivannan Sadhasivam wrote:
> On Thu, Apr 18, 2024 at 11:12:09AM -0500, Bjorn Helgaas wrote:
> > On Thu, Apr 18, 2024 at 05:28:31PM +0530, Manivannan Sadhasivam wrote:
> ...

> > > - * pci_epc_bme_notify() - Notify the EPF device that the EPC device has received
> > > - *			  the BME event from the Root complex
> > > - * @epc: the EPC device that received the BME event
> > > + * pci_epc_bus_master_enable_notify() - Notify the EPF device that the EPC
> > > + *					device has received the Bus Master
> > > + *					Enable event from the Root complex
> > > + * @epc: the EPC device that received the Bus Master Enable event
> > >   *
> > >   * Invoke to Notify the EPF device that the EPC device has received the Bus
> > > - * Master Enable (BME) event from the Root complex
> > > + * Master Enable event from the Root complex
> > 
> > There's no "set Bus Master Enable" transaction that would appear on
> > the PCIe link, so I assume "the Bus Master Enable event from the Root
> > Complex" is a way of saying something like "host has written the
> > Command register to set the Bus Master Enable bit"?
> > 
> 
> Yes. But looking at it again, it could be reworded as below:
> 
> 'Invoke to notify the EPF device that the EPC device has generated the Bus
> Master Enable event due to host setting the Bus Master Enable bit in the
> Command register.'

Sounds good.  Could even s/Invoke to notify/Notify/.