Re: [PATCH 2/6] rcu: Remove superfluous full memory barrier upon first EQS snapshot

[Andrea Parri]

> >> > @@ -773,7 +773,12 @@ static void rcu_gpnum_ovf(struct rcu_node *rnp, struct rcu_data *rdp)
> >> >   */
> >> >  static int dyntick_save_progress_counter(struct rcu_data *rdp)
> >> >  {
> >> > -	rdp->dynticks_snap = rcu_dynticks_snap(rdp->cpu);
> >>
> >> So for PPC, which gets the smp_mb() at the lock acquisition, this is an
> >> "obvious" redundant smp_mb().
> >>
> >> For the other archs, per the definition of smp_mb__after_unlock_lock() it
> >> seems implied that UNLOCK+LOCK is a full memory barrier, but I wanted to
> >> see it explicitly stated somewhere. From a bit of spelunking below I still
> >> think it's the case, but is there a "better" source of truth?
> >>
> >>   01352fb81658 ("locking: Add an smp_mb__after_unlock_lock() for UNLOCK+BLOCK barrier")
> >>   """
> >>   The Linux kernel has traditionally required that an UNLOCK+LOCK pair act as a
> >>   full memory barrier when either (1) that UNLOCK+LOCK pair was executed by the
> >>   same CPU or task, or (2) the same lock variable was used for the UNLOCK and
> >>   LOCK.
> >>   """
> >>
> >> and
> >>
> >>   https://lore.kernel.org/all/1436789704-10086-1-git-send-email-will.deacon@xxxxxxx/
> >>   """
> >>   This ordering guarantee is already provided without the barrier on
> >>   all architectures apart from PowerPC
> >>   """
> >
> > You seem to have found the accurate informations! But I must admit
> > they are hard to find and it would be welcome to document that properly, for example
> > in Documentation/memory-barriers.txt
> >
> > I think the reason is that it's not supposed to be used outside RCU, perhaps
> > because its semantics are too fragile to use for general purpose? Even that
> > could be stated along in Documentation/memory-barriers.txt
> >
> 
> That's also what I suspected when I stumbled on
> 
>   12d560f4ea87 ("rcu,locking: Privatize smp_mb__after_unlock_lock()")
> 
> which removed the references to it from Documentation/memory-barriers.txt
> 
> > Another thing is that its semantics are similar to smp_mb__after_spinlock()
> > (itself badly documented), although slightly different. I'm not even completely
> > sure how. I assume that smp_mb__after_spinlock() can be just used once to
> > produce the required ordering and subsequent lock on that spinlock don't need
> > to repeat the barrier to propagate the ordering against what is before the
> > smp_mb__after_spinlock. However IUUC smp_mb__after_unlock_lock() has to be
> > chained/repeated on all subsequent locking of the spinlock...
> 
> IIUC (big if) the chaining is a requirement of RCU itself, per:
> 
>   2a67e741bbbc ("rcu: Create transitive rnp->lock acquisition functions")
> 
>    * Because the rcu_nodes form a tree, the tree traversal locking will observe
>    * different lock values, this in turn means that an UNLOCK of one level
>    * followed by a LOCK of another level does not imply a full memory barrier;
>    * and most importantly transitivity is lost.
>    *
>    * In order to restore full ordering between tree levels, augment the regular
>    * lock acquire functions with smp_mb__after_unlock_lock().
> 

I know my remark may seem a little biased,  ;-) but the semantics of
smp_mb__after_unlock_lock() and smp_mb__after_spinlock() have been
somehowr/formally documented in the LKMM.  This means, in particular,
that one can write "litmus tests" with the barriers at stake and then
"run"/check such tests against the _current model.

For example,  (based on inline comments in include/linux/spinlock.h)

$ cat after_spinlock.litmus
C after_spinlock

{ }

P0(int *x, spinlock_t *s)
{
	spin_lock(s);
	WRITE_ONCE(*x, 1);
	spin_unlock(s);
}

P1(int *x, int *y, spinlock_t *s)
{
	int r0;

	spin_lock(s);
	smp_mb__after_spinlock();
	r0 = READ_ONCE(*x);
	WRITE_ONCE(*y, 1);
	spin_unlock(s);
}

P2(int *x, int *y)
{
	int r1;
	int r2;

	r1 = READ_ONCE(*y);
	smp_rmb();
	r2 = READ_ONCE(*x);
}

exists (1:r0=1 /\ 2:r1=1 /\ 2:r2=0)

$ herd7 -conf linux-kernel.cfg after_spinlock.litmus
Test after_spinlock Allowed
States 7
1:r0=0; 2:r1=0; 2:r2=0;
1:r0=0; 2:r1=0; 2:r2=1;
1:r0=0; 2:r1=1; 2:r2=0;
1:r0=0; 2:r1=1; 2:r2=1;
1:r0=1; 2:r1=0; 2:r2=0;
1:r0=1; 2:r1=0; 2:r2=1;
1:r0=1; 2:r1=1; 2:r2=1;
No
Witnesses
Positive: 0 Negative: 7
Condition exists (1:r0=1 /\ 2:r1=1 /\ 2:r2=0)
Observation after_spinlock Never 0 7
Time after_spinlock 0.01
Hash=b377bde8fe3565fcdd0eb2bdfaf3351e

Notice that, according to the current model at least, the state in
the above "exists" clause remains forbidden _after removal of the
smp_mb__after_spinlock() barrier.  In this sense, if you want, the
inline comment (I contributed to) is misleading/incomplete.  :-/

  Andrea