Re: [PATCH v2 2/2] iio: temperature: mcp9600: add threshold events support

[Dimitri Fedrau]

Am Mon, May 20, 2024 at 01:18:50PM +0100 schrieb Jonathan Cameron:
> On Sun, 19 May 2024 23:00:36 +0200
> Dimitri Fedrau <dima.fedrau@xxxxxxxxx> wrote:
> 
> > Am Sun, May 19, 2024 at 05:42:48PM +0100 schrieb Jonathan Cameron:
> > > On Fri, 17 May 2024 10:10:50 +0200
> > > Dimitri Fedrau <dima.fedrau@xxxxxxxxx> wrote:
> > >   
> > > > The device has four programmable temperature alert outputs which can be
> > > > used to monitor hot or cold-junction temperatures and detect falling and
> > > > rising temperatures. It supports up to 255 degree celsius programmable
> > > > hysteresis. Each alert can be individually configured by setting following
> > > > options in the associated alert configuration register:
> > > > - monitor hot or cold junction temperature
> > > > - monitor rising or falling temperature
> > > > - set comparator or interrupt mode
> > > > - set output polarity
> > > > - enable alert
> > > > 
> > > > This patch binds alert outputs to iio events:
> > > > - alert1: hot junction, rising temperature
> > > > - alert2: hot junction, falling temperature
> > > > - alert3: cold junction, rising temperature
> > > > - alert4: cold junction, falling temperature
> > > > 
> > > > All outputs are set in comparator mode and polarity depends on interrupt
> > > > configuration.
> > > > 
> > > > Signed-off-by: Dimitri Fedrau <dima.fedrau@xxxxxxxxx>  
> > > Hi Dmitri  
> > 
> > Hi Jonathan,
> > 
> > > Please make sure to address all questions in earlier reviews, either by
> > > changing the code, or directly answering the question.
> > >  
> > I did, see: https://lore.kernel.org/linux-iio/20240509204559.GB3614@debian/T/#u
> > or did I miss anything ? I'm a little bit confused.
> 
> I think some emails went astray :( Sorry I didn't check the archive.
> 
> Anyhow, thanks for providing the links.
>
Just thought you were to busy to reply and that's because I had send a new
version of the series.

> Jonathan
>