[PATCH 2/8] accel/habanalabs: check for errors after preboot is ready

[Ofir Bitton]

From: Farah Kassabri <fkassabri@xxxxxxxxx>

Driver should check and report any fatal errors detected by preboot,
before it attempts to load the boot fit.
Some errors may cause the driver to stop the boot process and mark
the device as unusable.
This check will allow the driver to fail and print the error reported
by preboot and skip the time wasting attempt of trying to load the
boot fit, which will fail due to the error.

Signed-off-by: Farah Kassabri <fkassabri@xxxxxxxxx>
Reviewed-by: Ofir Bitton <obitton@xxxxxxxxx>
---
 drivers/accel/habanalabs/common/firmware_if.c | 24 +++++++++----------
 1 file changed, 12 insertions(+), 12 deletions(-)

diff --git a/drivers/accel/habanalabs/common/firmware_if.c b/drivers/accel/habanalabs/common/firmware_if.c
index 886b3c07503d..6f0c40b12072 100644
--- a/drivers/accel/habanalabs/common/firmware_if.c
+++ b/drivers/accel/habanalabs/common/firmware_if.c
@@ -1482,7 +1482,7 @@ int hl_fw_wait_preboot_ready(struct hl_device *hdev)
 {
 	struct pre_fw_load_props *pre_fw_load = &hdev->fw_loader.pre_fw_load;
 	u32 status = 0, timeout;
-	int rc, tries = 1;
+	int rc, tries = 1, fw_err = 0;
 	bool preboot_still_runs;
 
 	/* Need to check two possible scenarios:
@@ -1522,18 +1522,18 @@ int hl_fw_wait_preboot_ready(struct hl_device *hdev)
 		}
 	}
 
-	if (rc) {
+	/* If we read all FF, then something is totally wrong, no point
+	 * of reading specific errors
+	 */
+	if (status != -1)
+		fw_err = fw_read_errors(hdev, pre_fw_load->boot_err0_reg,
+					pre_fw_load->boot_err1_reg,
+					pre_fw_load->sts_boot_dev_sts0_reg,
+					pre_fw_load->sts_boot_dev_sts1_reg);
+	if (rc || fw_err) {
 		detect_cpu_boot_status(hdev, status);
-		dev_err(hdev->dev, "CPU boot ready timeout (status = %d)\n", status);
-
-		/* If we read all FF, then something is totally wrong, no point
-		 * of reading specific errors
-		 */
-		if (status != -1)
-			fw_read_errors(hdev, pre_fw_load->boot_err0_reg,
-						pre_fw_load->boot_err1_reg,
-						pre_fw_load->sts_boot_dev_sts0_reg,
-						pre_fw_load->sts_boot_dev_sts1_reg);
+		dev_err(hdev->dev, "CPU boot %s (status = %d)\n",
+				fw_err ? "failed due to an error" : "ready timeout", status);
 		return -EIO;
 	}
 
-- 
2.34.1