Re: [PATCH v2 0/7] arm64: qcom: allow up to 4 lanes for the Type-C DisplayPort Altmode

[Bjorn Andersson]

On Mon, May 27, 2024 at 10:42:32AM GMT, Neil Armstrong wrote:
> Register a typec mux in order to change the PHY mode on the Type-C
> mux events depending on the mode and the svid when in Altmode setup.
> 
> The DisplayPort phy should be left enabled if is still powered on
> by the DRM DisplayPort controller, so bail out until the DisplayPort
> PHY is not powered off.
> 
> The Type-C Mode/SVID only changes on plug/unplug, and USB SAFE states
> will be set in between of USB-Only, Combo and DisplayPort Only so
> this will leave enough time to the DRM DisplayPort controller to
> turn of the DisplayPort PHY.
> 
> The patchset also includes bindings changes and DT changes.
> 
> This has been successfully tested on an SM8550 board, but the
> Thinkpad X13s deserved testing between non-PD USB, non-PD DisplayPort,
> PD USB Hubs and PD Altmode Dongles to make sure the switch works
> as expected.
> 
> The DisplayPort 4 lanes setup can be check with:
> $ cat /sys/kernel/debug/dri/ae01000.display-controller/DP-1/dp_debug
> 	name = msm_dp
> 	drm_dp_link
> 		rate = 540000
> 		num_lanes = 4

Has the issue with the USB controller dying on us been resolved?

Regards,
Bjorn