Re: [PATCH v2 3/4] soundwire: bus: clean up probe warnings

[Johan Hovold]

On Tue, Jun 04, 2024 at 10:33:02AM +0200, Pierre-Louis Bossart wrote:
> On 6/4/24 02:52, Johan Hovold wrote:
> > Clean up the probe warning messages by using a common succinct format
> > (e.g. without __func__ and with a space after ':').

> > @@ -123,7 +123,7 @@ static int sdw_drv_probe(struct device *dev)
> >  	/* init the dynamic sysfs attributes we need */
> >  	ret = sdw_slave_sysfs_dpn_init(slave);
> >  	if (ret < 0)
> > -		dev_warn(dev, "Slave sysfs init failed:%d\n", ret);
> > +		dev_warn(dev, "failed to initialise sysfs: %d\n", ret);
> >  
> >  	/*
> >  	 * Check for valid clk_stop_timeout, use DisCo worst case value of
> > @@ -147,7 +147,7 @@ static int sdw_drv_probe(struct device *dev)
> >  	if (drv->ops && drv->ops->update_status) {
> >  		ret = drv->ops->update_status(slave, slave->status);
> >  		if (ret < 0)
> > -			dev_warn(dev, "%s: update_status failed with status %d\n", __func__, ret);
> > +			dev_warn(dev, "failed to update status: %d\n", ret);
> 
> the __func__ does help IMHO, 'failed to update status' is way too general...

Error messages printed with dev_warn will include the device and driver
names so this message will be quite specific still.

> Replacing 'with status' by ":" is fine, but do we really care about 10
> chars in a log?

It's not primarily about the numbers of characters but about consistency.

Johan