Hi Nathan,We have an EEPROM on our board with information on what is populated on that particular board. We will apply these overlays based on that EEPROM data.
On 29/05/24 04:21, Nathan Morrisson wrote:
Add three overlays to disable the eth phy, rtc, and spi nor. These
overlays will be used to disable device tree nodes for components
that are optionally not populated.
v2:
- Add build time tests in makefile
Nathan Morrisson (4):
arm64: dts: ti: k3-am64-phycore-som: Add serial_flash label
arm64: dts: ti: k3-am6xx-phycore-som: Add overlay to disable eth phyI am not sure if this a common practice to have overlays to disable
arm64: dts: ti: k3-am6xx-phycore-som: Add overlay to disable rtc
arm64: dts: ti: k3-am6xx-phycore-som: Add overlay to disabl spi nor
arch/arm64/boot/dts/ti/Makefile | 17 +++++++++++++++++
.../boot/dts/ti/k3-am64-phycore-som.dtsi | 2 +-
.../ti/k3-am6xx-phycore-disable-eth-phy.dtso | 19 +++++++++++++++++++
.../dts/ti/k3-am6xx-phycore-disable-rtc.dtso | 15 +++++++++++++++
.../ti/k3-am6xx-phycore-disable-spi-nor.dtso | 15 +++++++++++++++
5 files changed, 67 insertions(+), 1 deletion(-)
create mode 100644 arch/arm64/boot/dts/ti/k3-am6xx-phycore-disable-eth-phy.dtso
create mode 100644 arch/arm64/boot/dts/ti/k3-am6xx-phycore-disable-rtc.dtso
create mode 100644 arch/arm64/boot/dts/ti/k3-am6xx-phycore-disable-spi-nor.dtso
missing components (at least I dont see such dtso in kernel). I would
like to see an what DT maintainers feel as such dtsos can explode in
numbers.
Is this something that U-Boot can detect and fix up for the Linux DT?
Unpopulated SPI flash and RTC should ideally not be an issue as drivers
would gracefully fail albeit with some sort of error msg.
Not so sure about Eth PHYs though.
Also, Are these dtso's mutually exclusive? ie can SoM have SPI flash but
not RTC, have RTC and SPI Flash but no ETH PHY?