Re: [RFC PATCH 4/4] mmc: renesas_sdhi: Add support for RZ/V2H(P) SoC

[Lad, Prabhakar]

Hi Biju,

Thank you for the review.

On Thu, Jun 6, 2024 at 10:32 AM Biju Das <biju.das.jz@xxxxxxxxxxxxxx> wrote:
>
> Hi Prabhakar,
>
> Thanks for the feedback.
>
> > -----Original Message-----
> > From: Prabhakar <prabhakar.csengg@xxxxxxxxx>
> > Sent: Wednesday, June 5, 2024 8:50 AM
> > Subject: [RFC PATCH 4/4] mmc: renesas_sdhi: Add support for RZ/V2H(P) SoC
> >
> > From: Lad Prabhakar <prabhakar.mahadev-lad.rj@xxxxxxxxxxxxxx>
> >
> > The SDHI/eMMC IPs found in the RZ/V2H(P) (a.k.a. r9a09g057) are very similar to those found in R-
> > Car Gen3. However, they are not identical, necessitating an SoC-specific compatible string for
> > fine-tuning driver support.
> >
> > Key features of the RZ/V2H(P) SDHI/eMMC IPs include:
> > - Voltage level control via the IOVS bit.
> > - PWEN pin support via SD_STATUS register.
> > - Lack of HS400 support.
> > - Fixed address mode operation.
> >
> > sd_iovs and sd_pwen quirks are introduced for SoCs supporting this bit to handle voltage level
> > control and power enable via SD_STATUS register.
> >
> > regulator support is added to control the volatage levels of SD pins via sd_iovs bit in SD_STATUS
> > register.
> >
> > Signed-off-by: Lad Prabhakar <prabhakar.mahadev-lad.rj@xxxxxxxxxxxxxx>
> > ---
> >  drivers/mmc/host/renesas_sdhi.h               |  7 ++
> >  drivers/mmc/host/renesas_sdhi_core.c          | 67 +++++++++++++++++--
> >  drivers/mmc/host/renesas_sdhi_internal_dmac.c | 45 +++++++++++++
> >  drivers/mmc/host/tmio_mmc.h                   |  4 ++
> >  4 files changed, 118 insertions(+), 5 deletions(-)
> >
> > diff --git a/drivers/mmc/host/renesas_sdhi.h b/drivers/mmc/host/renesas_sdhi.h index
> > 586f94d4dbfd..9ef4fdf44280 100644
> > --- a/drivers/mmc/host/renesas_sdhi.h
> > +++ b/drivers/mmc/host/renesas_sdhi.h
> > @@ -11,6 +11,8 @@
> >
> >  #include <linux/dmaengine.h>
> >  #include <linux/platform_device.h>
> > +#include <linux/regmap.h>
> > +#include <linux/regulator/driver.h>
> >  #include "tmio_mmc.h"
> >
> >  struct renesas_sdhi_scc {
> > @@ -49,6 +51,11 @@ struct renesas_sdhi_quirks {
> >       bool manual_tap_correction;
> >       bool old_info1_layout;
> >       u32 hs400_bad_taps;
> > +     bool sd_iovs;
> > +     bool sd_pwen;
> > +     struct regulator_desc *rdesc;
> > +     const struct regmap_config *rdesc_regmap_config;
> > +     unsigned int rdesc_offset;
> >       const u8 (*hs400_calib_table)[SDHI_CALIB_TABLE_MAX];
> >  };
> >
> > diff --git a/drivers/mmc/host/renesas_sdhi_core.c b/drivers/mmc/host/renesas_sdhi_core.c
> > index 12f4faaaf4ee..2eeea9513a23 100644
> > --- a/drivers/mmc/host/renesas_sdhi_core.c
> > +++ b/drivers/mmc/host/renesas_sdhi_core.c
> > @@ -248,6 +248,19 @@ static int renesas_sdhi_card_busy(struct mmc_host *mmc)
> >                TMIO_STAT_DAT0);
> >  }
> >
> > +static void renesas_sdhi_sd_status_pwen(struct tmio_mmc_host *host,
> > +bool on) {
> > +     u32 sd_status;
> > +
> > +     sd_ctrl_read32_rep(host, CTL_SD_STATUS, &sd_status, 1);
> > +     if (on)
> > +             sd_status |=  SD_STATUS_PWEN;
> > +     else
> > +             sd_status &=  ~SD_STATUS_PWEN;
> > +
> > +     sd_ctrl_write32(host, CTL_SD_STATUS, sd_status); }
> > +
>
> May be use regulator_set_voltage() to set this??
>
This is the PWEN bit which is not modelled as a regulator, we cannot
use regulator_set_voltage() to set this bit.

> >  static int renesas_sdhi_start_signal_voltage_switch(struct mmc_host *mmc,
> >                                                   struct mmc_ios *ios)
> >  {
> > @@ -587,6 +600,9 @@ static void renesas_sdhi_reset(struct tmio_mmc_host *host, bool preserve)
> >                                         false, priv->rstc);
> >                       /* At least SDHI_VER_GEN2_SDR50 needs manual release of reset */
> >                       sd_ctrl_write16(host, CTL_RESET_SD, 0x0001);
> > +                     if (sdhi_has_quirk(priv, sd_pwen))
> > +                             renesas_sdhi_sd_status_pwen(host, true);
> > +
> >                       priv->needs_adjust_hs400 = false;
> >                       renesas_sdhi_set_clock(host, host->clk_cache);
> >
> > @@ -904,6 +920,34 @@ static void renesas_sdhi_enable_dma(struct tmio_mmc_host *host, bool enable)
> >       renesas_sdhi_sdbuf_width(host, enable ? width : 16);  }
> >
> > +static int renesas_sdhi_internal_dmac_register_regulator(struct platform_device *pdev,
> > +                                                      const struct renesas_sdhi_quirks *quirks) {
> > +     struct tmio_mmc_host *host = platform_get_drvdata(pdev);
> > +     struct renesas_sdhi *priv = host_to_priv(host);
> > +     struct regulator_config rcfg = {
> > +             .dev = &pdev->dev,
> > +             .driver_data = priv,
> > +     };
> > +     struct regulator_dev *rdev;
> > +     const char *devname;
> > +
> > +     devname = devm_kasprintf(&pdev->dev, GFP_KERNEL, "%s-vqmmc-regulator",
> > +                              dev_name(&pdev->dev));
> > +     if (!devname)
> > +             return -ENOMEM;
> > +
> > +     quirks->rdesc->name = devname;
> > +     rcfg.regmap = devm_regmap_init_mmio(&pdev->dev, host->ctl + quirks->rdesc_offset,
>
> This is (CTL_SD_STATUS << 2) , so the variable can be dropped from quirks.
>
rdesc_offset is added to make code generic, that is in future if there
is a new chip with a different offset which supports IOVS we can just
pass the offset for it.

Cheers,
Prabhakar