Re: [PATCH 1/1] virtio-can: Add link to CAN specification from ISO.
From: Vincent Mailhol
Date: Thu Jun 06 2024 - 23:44:15 EST
On Thu. 6 Jun. 2024 at 23:26, Harald Mommer
<Harald.Mommer@xxxxxxxxxxxxxxx> wrote:
> Add link to the CAN specification in the ISO shop.
>
> ISO 11898-1:2015
> Road vehicles
> Controller area network (CAN)
> Part 1: Data link layer and physical signalling
>
> The specification is not freely obtainable there.
> ---
> introduction.tex | 3 ++-
> 1 file changed, 2 insertions(+), 1 deletion(-)
>
> diff --git a/introduction.tex b/introduction.tex
> index 8bcef03..72573d6 100644
> --- a/introduction.tex
> +++ b/introduction.tex
Excuse my ignorance, this is not a patch toward the Linux tree, right?
Could you let me know which git tree this patch is targetting?
> @@ -142,7 +142,8 @@ \section{Normative References}\label{sec:Normative References}
> TRANSMISSION CONTROL PROTOCOL
> \newline\url{https://www.rfc-editor.org/rfc/rfc793}\\
> \phantomsection\label{intro:CAN}\textbf{[CAN]} &
> - ISO 11898-1:2015 Road vehicles -- Controller area network (CAN) -- Part 1: Data link layer and physical signalling\\
> + ISO 11898-1:2015 Road vehicles -- Controller area network (CAN) -- Part 1: Data link layer and physical signalling
> + \newline\url{https://www.iso.org/standard/63648.html}\\
> \end{longtable}
I just realised that ISO 11898-1:2024 was published last month:
https://www.iso.org/standard/86384.html.
Just for confirmation, are you keeping the reference to ISO
11898-1:2015 until CAN XL support gets added? If yes, OK as-is.
On my side, I now need to read the new ISO 11898-1:2024.
>
> \section{Non-Normative References}
> --
> 2.34.1
>
>