[PATCH v2 1/2] ASoC: dt-bindings: tlv320adc3xxx: Add MICBIAS-as-GPO properties

[Ricard Wanderlof]

Add properties for configuring the MICBIAS pins as general purpose
outputs, with some limitations: The voltage on the pin when activated
may be set using another property to 2.0 V, 2.5 V or AVDD.
When deactivated the pin will float.

Signed-off-by: Ricard Wanderlof <ricard.wanderlof@xxxxxxxx>
---
 .../bindings/sound/ti,tlv320adc3xxx.yaml           | 24 ++++++++++++++++++++++
 1 file changed, 24 insertions(+)

diff --git a/Documentation/devicetree/bindings/sound/ti,tlv320adc3xxx.yaml b/Documentation/devicetree/bindings/sound/ti,tlv320adc3xxx.yaml
index ede14ca2c07a..b7cae1c65e84 100644
--- a/Documentation/devicetree/bindings/sound/ti,tlv320adc3xxx.yaml
+++ b/Documentation/devicetree/bindings/sound/ti,tlv320adc3xxx.yaml
@@ -82,6 +82,26 @@ properties:
       Note that there is currently no support for reading the GPIO pins as
       inputs.
 
+  ti,micbias1-gpo:
+    type: boolean
+    description: |
+      When set, the MICBIAS1 pin may be controlled via the GPIO framework,
+      as pin number 3 on the device.
+
+      In this mode, when the pin is activated, it will be set to the voltage
+      specified by the ti,micbias1-vg property. When deactivated, the pin will
+      float.
+
+  ti,micbias2-gpo:
+    type: boolean
+    description: |
+      When set, the MICBIAS2 pin may be controlled via the GPIO framework,
+      as pin number 4 on the device.
+
+      In this mode, when the pin is activated, it will be set to the voltage
+      specified by the ti,micbias2-vg property. When deactivated, the pin will
+      float.
+
   ti,micbias1-vg:
     $ref: /schemas/types.yaml#/definitions/uint32
     enum:
@@ -104,6 +124,10 @@ properties:
     description: |
       Mic bias voltage output on MICBIAS2 pin
 
+dependencies:
+  ti,micbias1-gpio: [ti,micbias1-vg]
+  ti,micbias2-gpio: [ti,micbias2-vg]
+
 required:
   - compatible
   - reg

-- 
2.30.2