Re: [PATCH v4 4/6] spi: spi-axi-spi-engine: Add support for MOSI idle configuration

From: David Lechner
Date: Wed Jun 19 2024 - 09:57:01 EST


On 6/18/24 6:11 PM, Marcelo Schmitt wrote:
> Implement MOSI idle low and MOSI idle high to better support peripherals
> that request specific MOSI behavior.
>
> Signed-off-by: Marcelo Schmitt <marcelo.schmitt@xxxxxxxxxx>
> ---
> drivers/spi/spi-axi-spi-engine.c | 8 ++++++++
> 1 file changed, 8 insertions(+)
>
> diff --git a/drivers/spi/spi-axi-spi-engine.c b/drivers/spi/spi-axi-spi-engine.c
> index 0aa31d745734..787e22ae80c0 100644
> --- a/drivers/spi/spi-axi-spi-engine.c
> +++ b/drivers/spi/spi-axi-spi-engine.c
> @@ -41,6 +41,7 @@
> #define SPI_ENGINE_CONFIG_CPHA BIT(0)
> #define SPI_ENGINE_CONFIG_CPOL BIT(1)
> #define SPI_ENGINE_CONFIG_3WIRE BIT(2)
> +#define SPI_ENGINE_CONFIG_SDO_IDLE BIT(3)

Calling this SPI_ENGINE_CONFIG_SDO_IDLE_HIGH would make it more
clear what happens when the bit is enabled.

>
> #define SPI_ENGINE_INST_TRANSFER 0x0
> #define SPI_ENGINE_INST_ASSERT 0x1
> @@ -132,6 +133,10 @@ static unsigned int spi_engine_get_config(struct spi_device *spi)
> config |= SPI_ENGINE_CONFIG_CPHA;
> if (spi->mode & SPI_3WIRE)
> config |= SPI_ENGINE_CONFIG_3WIRE;
> + if (spi->mode & SPI_MOSI_IDLE_HIGH)
> + config |= SPI_ENGINE_CONFIG_SDO_IDLE;
> + if (spi->mode & SPI_MOSI_IDLE_LOW)
> + config &= ~SPI_ENGINE_CONFIG_SDO_IDLE;
>
> return config;
> }
> @@ -646,6 +651,9 @@ static int spi_engine_probe(struct platform_device *pdev)
>
> host->dev.of_node = pdev->dev.of_node;
> host->mode_bits = SPI_CPOL | SPI_CPHA | SPI_3WIRE;
> + if (ADI_AXI_PCORE_VER_MAJOR(version) >= 1 &&

Currently, the major version is required to be 1, so this check is not
strictly needed.

> + ADI_AXI_PCORE_VER_MINOR(version) >= 3)
> + host->mode_bits |= SPI_MOSI_IDLE_LOW | SPI_MOSI_IDLE_HIGH;



> host->bits_per_word_mask = SPI_BPW_RANGE_MASK(1, 32);
> host->max_speed_hz = clk_get_rate(spi_engine->ref_clk) / 2;
> host->transfer_one_message = spi_engine_transfer_one_message;