Re: [PATCH 2/5] arm64: dts: rockchip: Fix regulators, gmac and naming on NanoPi R6C/R6S

From: Heiko Stübner
Date: Thu Jun 20 2024 - 14:49:33 EST


Am Mittwoch, 12. Juni 2024, 22:48:11 CEST schrieb Sebastian Kropatsch:
> Fix the alphabetical ordering in some nodes and rename some regulators
> and pins to match the schematics [1][2] as well as to adhere to
> preferred naming schemes.

General rule of thumb, when you need an "and" in your subject or a list
like the above - you definitly want to split the change into multiple
commits.

> In addition to that:
> * vcc_3v3_sd_s0: Fix voltage to be 3.3V
> * vcc3v3_pcie:
> - Move to NanoPi R6C, this power switch is not available on R6S
> - Fix vin-supply (is vcc_5v0 per schematics)
> - Add gpios/pincrtl to enable power

this defnitly needs its own patch

> * vcc5v0_usb: Remove this regulator since according to the schematics,

this too

> * vcc5v0_host_20 and vcc5v0_usb_otg0 are directly powered by vcc_5v0

this could be grouped together with the 3.3v change

> * gmac1: Add rx_delay of 0 (no delay since phy-mode = "rgmii-rxid")

with rxid mode, why is the rx_delay needed at all?
Shouldn't this just work without the property?

> * rgmii_phy1: Add phy-supply as seen in schematics

separate patch

> * pcie2*:
> - Add pinctrl reset pins
> - Update vpcie3v3-supply to match the schematics

separate patch

> * sdhci: Add vmmc-supply and vqmmc-supply

separate patch


Heiko