Re: [PATCH v4] can: m_can: don't enable transceiver when probing

[Marc Kleine-Budde]

On 07.06.2024 12:52:08, Martin Hundebøll wrote:
> The m_can driver sets and clears the CCCR.INIT bit during probe (both
> when testing the NON-ISO bit, and when configuring the chip). After
> clearing the CCCR.INIT bit, the transceiver enters normal mode, where it
> affects the CAN bus (i.e. it ACKs frames). This can cause troubles when
> the m_can node is only used for monitoring the bus, as one cannot setup
> listen-only mode before the device is probed.
> 
> Rework the probe flow, so that the CCCR.INIT bit is only cleared when
> upping the device. First, the tcan4x5x driver is changed to stay in
> standby mode during/after probe. This in turn requires changes when
> setting bits in the CCCR register, as its CSR and CSA bits are always
> high in standby mode.
> 
> Signed-off-by: Martin Hundebøll <martin@xxxxxxxxxx>

Applied to linux-can-next.

Thanks,
Marc

-- 
Pengutronix e.K.                 | Marc Kleine-Budde          |
Embedded Linux                   | https://www.pengutronix.de |
Vertretung Nürnberg              | Phone: +49-5121-206917-129 |
Amtsgericht Hildesheim, HRA 2686 | Fax:   +49-5121-206917-9   |

Attachment: signature.asc
Description: PGP signature