Re: [PATCH net v1 1/1] net: phy: micrel: ksz8081: disable broadcast only if PHY address is not 0

[Jakub Kicinski]

On Thu, 27 Jun 2024 07:33:53 +0200 Oleksij Rempel wrote:
> Do not disable broadcast if we are using address 0 (broadcast) to
> communicate with this device. Otherwise we will use proper driver but no
> communication will be possible and no link changes will be detected.
> There are two scenarios where we can run in to this situation:
> - PHY is bootstrapped for address 0
> - no PHY address is known and linux is scanning the MDIO bus, so first
>   respond and attached device will be on address 0.
> 
> The fixes tag points to the latest refactoring, not to the initial point
> where kszphy_broadcast_disable() was introduced.
> 
> Fixes: 79e498a9c7da0 ("net: phy: micrel: Restore led_mode and clk_sel on resume")

Is there a reason you're not CCing the author ?