Re: [PATCH v3 1/3] dt-bindings: iio: pressure: Add Sensirion SDP500

From: Krzysztof Kozlowski
Date: Thu Jul 04 2024 - 05:47:52 EST


On 04/07/2024 10:18, Petar Stoykov wrote:
> On Tue, Jul 2, 2024 at 5:15 PM Krzysztof Kozlowski
> <krzysztof.kozlowski@xxxxxxxxxx> wrote:
>>
>> On 02/07/2024 16:59, Petar Stoykov via B4 Relay wrote:
>>> From: Petar Stoykov <pd.pstoykov@xxxxxxxxx>
>>>
>>> Sensirion SDP500 is a digital differential pressure sensor. It provides
>>> a digital I2C output. Add devicetree bindings requiring the compatible
>>> string and I2C slave address (reg).
>>>
>>
>> You did not test your code before sending.
>
> I tested the driver for sdp500 on our system and it worked well.
> I must admit that I forgot to change the dts to sdp510 and retest.
>
>>
>> Please respond to existing feedback from v1 and v2, thus confirm that
>> you understood it and you are or are not going to implement it.
>>
>
> I tried to reply to all previous comments. Sorry if I missed something.
>
>> It does not look like you tested the bindings, at least after quick
>> look. Please run `make dt_binding_check` (see
>> Documentation/devicetree/bindings/writing-schema.rst for instructions).
>> Maybe you need to update your dtschema and yamllint.
>
> I didn't know about that dt_binding_check. Then I spent a few hours
> yesterday fighting with dependencies to get it running.

It's just one command:
pipx install dtschema yamllint
(or pip, depending on your system)

Best regards,
Krzysztof