Re: [PATCH iwl-net v2 3/3] igc: Fix qbv tx latency by setting gtxoffset

[Vinicius Costa Gomes]

Faizal Rahim <faizal.abdul.rahim@xxxxxxxxxxxxxxx> writes:

> A large tx latency issue was discovered during testing when only QBV was
> enabled. The issue occurs because gtxoffset was not set when QBV is
> active, it was only set when launch time is active.
>
> The patch "igc: Correct the launchtime offset" only sets gtxoffset when
> the launchtime_enable field is set by the user. Enabling launchtime_enable
> ultimately sets the register IGC_TXQCTL_QUEUE_MODE_LAUNCHT (referred to as
> LaunchT in the SW user manual).
>
> Section 7.5.2.6 of the IGC i225/6 SW User Manual Rev 1.2.4 states:
> "The latency between transmission scheduling (launch time) and the
> time the packet is transmitted to the network is listed in Table 7-61."
>
> However, the patch misinterprets the phrase "launch time" in that section
> by assuming it specifically refers to the LaunchT register, whereas it
> actually denotes the generic term for when a packet is released from the
> internal buffer to the MAC transmit logic.
>
> This launch time, as per that section, also implicitly refers to the QBV
> gate open time, where a packet waits in the buffer for the QBV gate to
> open. Therefore, latency applies whenever QBV is in use. TSN features such
> as QBU and QAV reuse QBV, making the latency universal to TSN features.
>
> Discussed with i226 HW owner (Shalev, Avi) and we were in agreement that
> the term "launch time" used in Section 7.5.2.6 is not clear and can be
> easily misinterpreted. Avi will update this section to:
> "When TQAVCTRL.TRANSMIT_MODE = TSN, the latency between transmission
> scheduling and the time the packet is transmitted to the network is listed
> in Table 7-61."
>
> Fix this issue by using igc_tsn_is_tx_mode_in_tsn() as a condition to
> write to gtxoffset, aligning with the newly updated SW User Manual.
>
> Tested:
> 1. Enrol taprio on talker board
>    base-time 0
>    cycle-time 1000000
>    flags 0x2
>    index 0 cmd S gatemask 0x1 interval1
>    index 0 cmd S gatemask 0x1 interval2
>
>    Note:
>    interval1 = interval for a 64 bytes packet to go through
>    interval2 = cycle-time - interval1
>
> 2. Take tcpdump on listener board
>
> 3. Use udp tai app on talker to send packets to listener
>
> 4. Check the timestamp on listener via wireshark
>
> Test Result:
> 100 Mbps: 113 ~193 ns
> 1000 Mbps: 52 ~ 84 ns
> 2500 Mbps: 95 ~ 223 ns
>
> Note that the test result is similar to the patch "igc: Correct the
> launchtime offset".
>
> Fixes: 790835fcc0cb ("igc: Correct the launchtime offset")
> Signed-off-by: Faizal Rahim <faizal.abdul.rahim@xxxxxxxxxxxxxxx>
> Reviewed-by: Simon Horman <horms@xxxxxxxxxx>
> ---

Good catch.

Acked-by: Vinicius Costa Gomes <vinicius.gomes@xxxxxxxxx>

>  drivers/net/ethernet/intel/igc/igc_tsn.c | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/drivers/net/ethernet/intel/igc/igc_tsn.c b/drivers/net/ethernet/intel/igc/igc_tsn.c
> index 9fafe275f30f..efe13a9350ca 100644
> --- a/drivers/net/ethernet/intel/igc/igc_tsn.c
> +++ b/drivers/net/ethernet/intel/igc/igc_tsn.c
> @@ -61,7 +61,7 @@ void igc_tsn_adjust_txtime_offset(struct igc_adapter *adapter)
>  	struct igc_hw *hw = &adapter->hw;
>  	u16 txoffset;
>  
> -	if (!is_any_launchtime(adapter))
> +	if (!igc_tsn_is_tx_mode_in_tsn(adapter))
>  		return;
>  
>  	switch (adapter->link_speed) {
> -- 
> 2.25.1
>


Cheers,
-- 
Vinicius