Re: [RFC 1/5] selftests: KVM: Add a basic SNP smoke test
From: Peter Gonda
Date: Thu Jul 11 2024 - 11:16:57 EST
On Wed, Jul 10, 2024 at 4:06 PM Pratik R. Sampat
<pratikrajesh.sampat@xxxxxxx> wrote:
>
> Extend sev_smoke_test to also run a minimal SEV-SNP smoke test that
> initializes and sets up private memory regions required to run a simple
> SEV-SNP guest.
>
> Similar to it's SEV-ES smoke test counterpart, this also does not support
> GHCB and ucall yet and uses the GHCB MSR protocol to trigger an exit of
> the type KVM_EXIT_SYSTEM_EVENT.
>
> Also, decouple policy and type and require functions to provide both
> such that there is no assumption regarding the type using policy.
>
> Signed-off-by: Pratik R. Sampat <pratikrajesh.sampat@xxxxxxx>
Tested-by: Peter Gonda <pgonda@xxxxxxxxxx>
>
> - test_sev(guest_sev_code, SEV_POLICY_NO_DBG);
> - test_sev(guest_sev_code, 0);
> + test_sev(guest_sev_code, KVM_X86_SEV_VM, SEV_POLICY_NO_DBG);
> + test_sev(guest_sev_code, KVM_X86_SEV_VM, 0);
>
> if (kvm_cpu_has(X86_FEATURE_SEV_ES)) {
> - test_sev(guest_sev_es_code, SEV_POLICY_ES | SEV_POLICY_NO_DBG);
> - test_sev(guest_sev_es_code, SEV_POLICY_ES);
> + test_sev(guest_sev_es_code, KVM_X86_SEV_ES_VM, SEV_POLICY_ES | SEV_POLICY_NO_DBG);
> + test_sev(guest_sev_es_code, KVM_X86_SEV_ES_VM, SEV_POLICY_ES);
> +
> + if (kvm_has_cap(KVM_CAP_XCRS) &&
> + (xgetbv(0) & XFEATURE_MASK_X87_AVX) == XFEATURE_MASK_X87_AVX) {
> + test_sync_vmsa(KVM_X86_SEV_ES_VM, SEV_POLICY_ES);
> + test_sync_vmsa(KVM_X86_SEV_ES_VM, SEV_POLICY_ES | SEV_POLICY_NO_DBG);
> + }
> + }
> +
> + if (kvm_cpu_has(X86_FEATURE_SNP) && is_kvm_snp_supported()) {
> + test_sev(guest_snp_code, KVM_X86_SNP_VM, SNP_POLICY_SMT | SNP_POLICY_RSVD_MBO);
I'd guess most systems have SMT enabled, but is there a way we can
check and toggle the SNP_POLICY_SMT policy bit programmatically?
Also should we have a base SNP policy so we don't have to read
`SNP_POLICY_SMT | SNP_POLICY_RSVD_MBO` every time? Not sure I think
selftests prefer more verbosity.