[PATCH v3 2/2] arm64: dts: qcom: x1e80100-yoga: Update panel bindings

[Rob Clark]

From: Rob Clark <robdclark@xxxxxxxxxxxx>

Use the correct panel compatible, and wire up enable-gpio.  It is wired
up in the same way as the x1e80100-crd.

Signed-off-by: Rob Clark <robdclark@xxxxxxxxxxxx>
Reviewed-by: Abel Vesa <abel.vesa@xxxxxxxxxx>
---
Note that the power-source differs from the CRD.  Figured that out by
diffing $debugfs/gpio.

 .../dts/qcom/x1e80100-lenovo-yoga-slim7x.dts    | 17 +++++++++++++++--
 1 file changed, 15 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/qcom/x1e80100-lenovo-yoga-slim7x.dts b/arch/arm64/boot/dts/qcom/x1e80100-lenovo-yoga-slim7x.dts
index 70977e9fa266..6f8d52c368a4 100644
--- a/arch/arm64/boot/dts/qcom/x1e80100-lenovo-yoga-slim7x.dts
+++ b/arch/arm64/boot/dts/qcom/x1e80100-lenovo-yoga-slim7x.dts
@@ -190,7 +190,6 @@ vreg_edp_3p3: regulator-edp-3p3 {
 		pinctrl-0 = <&edp_reg_en>;
 		pinctrl-names = "default";
 
-		regulator-always-on;
 		regulator-boot-on;
 	};
 
@@ -592,9 +591,13 @@ &mdss_dp3 {
 
 	aux-bus {
 		panel {
-			compatible = "edp-panel";
+			compatible = "samsung,atna45dc02", "samsung,atna33xc20";
+			enable-gpios = <&pmc8380_3_gpios 4 GPIO_ACTIVE_HIGH>;
 			power-supply = <&vreg_edp_3p3>;
 
+			pinctrl-0 = <&edp_bl_en>;
+			pinctrl-names = "default";
+
 			port {
 				edp_panel_in: endpoint {
 					remote-endpoint = <&mdss_dp3_out>;
@@ -669,6 +672,16 @@ &pcie6a_phy {
 	status = "okay";
 };
 
+&pmc8380_3_gpios {
+	edp_bl_en: edp-bl-en-state {
+		pins = "gpio4";
+		function = "normal";
+		power-source = <0>; /* 1.8V */
+		input-disable;
+		output-enable;
+	};
+};
+
 &qupv3_0 {
 	status = "okay";
 };
-- 
2.45.2