Re: [PATCH v6 3/5] media: platform: mediatek: isp_30: add mediatek ISP3.0 sensor interface

[Julien Stephan]

Le mar. 30 juil. 2024 à 15:29, Laurent Pinchart
<laurent.pinchart@xxxxxxxxxxxxxxxx> a écrit :
[...]
> > +             mtk_seninf_update(priv, SENINF_TOP_PHY_SENINF_CTL_CSI0, DPHY_MODE, 0 /* 4D1C*/);
>
> As this is a V4L2 driver, I'm pretty sure someone will ask for
>
>                 mtk_seninf_update(priv, SENINF_TOP_PHY_SENINF_CTL_CSI0,
>                                   DPHY_MODE, 0 /* 4D1C*/);
>
> I wouldn't care too much about going slightly over 80 characters, but
> getting close to 100 where lines could be wrapped without hindering
> readability will likely upset some people. Same in other places where
> applicable.
>

Hi Laurent,

On an early version of this series, Angelo asked me to un-wrap lines
that can fit into 100 chars...
Both are fine for me, we just need to agree on something here ....

[...]
> > +     /* Configure timestamp */
> > +     writel(SENINF_TIMESTAMP_STEP, input->base + SENINF_TG1_TM_STP);
>
> Can we have a mtk_seninf_input_write(), the same way we have
> mtk_seninf_mux_write() ? Same for writes to priv->base below, with a
> mtk_seninf_write() inline function.
>

... and here :) In an early review Angelo also  asked me to remove
these accessors.

I can add them back and reduce line chars if needed.

Cheers
Julien