Re: [PATCH] clockevents/drivers/i8253: Do not zero timer counter in shutdown
From: Thomas Gleixner
Date: Thu Aug 01 2024 - 14:57:19 EST
On Thu, Aug 01 2024 at 19:25, David Woodhouse wrote:
> On Thu, 2024-08-01 at 18:49 +0100, David Woodhouse wrote:
>> > The stop sequence is wrong:
>> >
>> > When there is a count in progress, writing a new LSB before the
>> > counter has counted down to 0 and rolled over to FFFFh, WILL stop
>> > the counter. However, if the LSB is loaded AFTER the counter has
>> > rolled over to FFFFh, so that an MSB now exists in the counter, then
>> > the counter WILL NOT stop.
>> >
>> > The original i8253 datasheet says:
>> >
>> > 1) Write 1st byte stops the current counting
>> > 2) Write 2nd byte starts the new count
>>
>
> It also prefixes that with "Rewriting a counter register during
> counting results in the following:".
>
> But after you write the MODE register, is it actually supposed to be
> counting? Just a little further up, under 'Counter Loading', it says:
It's not counting right out of reset. But once it started counting it's
tedious to stop :)
> "The count register is not loaded until the count value is written (one
> or two bytes, depending on the mode selected by the RL bits), followed
> by a rising edge and a falling edge of the clock. Any read of the
> counter prior to that falling clock edge may yield invalid data".
>
> OK, but what *triggers* that invalid state? Given that it explicitly
> says that a one-byte counter write ends that state, it isn't the first
> of two bytes. Surely that means that from the time the MODE register is
> written, any read of the counter may yield invalid data, until the
> counter is written?
It seems to keep ticking with the old value.
> I suspect there are as many implementations (virt and hardware) as
> there are reasonable interpretations of the spec... and then some.
Indeed.
Thanks,
tglx