Re: [PATCH net v1] pse-core: Conditionally set current limit during PI regulator registration

[Kyle Swenson]

On Tue, Aug 13, 2024 at 09:37:19AM +0200, Oleksij Rempel wrote:
> Fix an issue where `devm_regulator_register()` would fail for PSE
> controllers that do not support current limit control, such as simple
> GPIO-based controllers like the podl-pse-regulator. The
> `REGULATOR_CHANGE_CURRENT` flag and `max_uA` constraint are now
> conditionally set only if the `pi_set_current_limit` operation is
> supported. This change prevents the regulator registration routine from
> attempting to call `pse_pi_set_current_limit()`, which would return
> `-EOPNOTSUPP` and cause the registration to fail.
> 
> Fixes: 4a83abcef5f4f ("net: pse-pd: Add new power limit get and set c33 features")
> Signed-off-by: Oleksij Rempel <o.rempel@xxxxxxxxxxxxxx>
> ---
>  drivers/net/pse-pd/pse_core.c | 11 ++++++++---
>  1 file changed, 8 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/net/pse-pd/pse_core.c b/drivers/net/pse-pd/pse_core.c
> index ec20953e0f825..4f032b16a8a0a 100644
> --- a/drivers/net/pse-pd/pse_core.c
> +++ b/drivers/net/pse-pd/pse_core.c
> @@ -401,9 +401,14 @@ devm_pse_pi_regulator_register(struct pse_controller_dev *pcdev,
>  	rdesc->ops = &pse_pi_ops;
>  	rdesc->owner = pcdev->owner;
> 
> -	rinit_data->constraints.valid_ops_mask = REGULATOR_CHANGE_STATUS |
> -						 REGULATOR_CHANGE_CURRENT;
> -	rinit_data->constraints.max_uA = MAX_PI_CURRENT;
> +	rinit_data->constraints.valid_ops_mask = REGULATOR_CHANGE_STATUS;
> +
> +	if (pcdev->ops->pi_set_current_limit) {
> +		rinit_data->constraints.valid_ops_mask |=
> +			REGULATOR_CHANGE_CURRENT;
> +		rinit_data->constraints.max_uA = MAX_PI_CURRENT;
> +	}
> +
>  	rinit_data->supply_regulator = "vpwr";
> 
>  	rconfig.dev = pcdev->dev;
> --
> 2.39.2

This patch solves the problem I was having with the regulator setup for
the tps23881 on my hardware.  Great timing, and thanks for the fix!

Tested-by: Kyle Swenson <kyle.swenson@xxxxxxxx>