[PATCH net-next v2 3/5] net: xilinx: axienet: Don't print if we go into promiscuous mode

[Sean Anderson]

A message about being in promiscuous mode is printed every time each
additional multicast address beyond four is added. Suppress this message
like is done in other drivers.

Signed-off-by: Sean Anderson <sean.anderson@xxxxxxxxx>
---

Changes in v2:
- Split off IFF_PROMISC change

 drivers/net/ethernet/xilinx/xilinx_axienet_main.c | 2 --
 1 file changed, 2 deletions(-)

diff --git a/drivers/net/ethernet/xilinx/xilinx_axienet_main.c b/drivers/net/ethernet/xilinx/xilinx_axienet_main.c
index 1bcabb016ca9..9382ce50aeb2 100644
--- a/drivers/net/ethernet/xilinx/xilinx_axienet_main.c
+++ b/drivers/net/ethernet/xilinx/xilinx_axienet_main.c
@@ -447,7 +447,6 @@ static void axienet_set_multicast_list(struct net_device *ndev)
 		reg = axienet_ior(lp, XAE_FMI_OFFSET);
 		reg |= XAE_FMI_PM_MASK;
 		axienet_iow(lp, XAE_FMI_OFFSET, reg);
-		dev_info(&ndev->dev, "Promiscuous mode enabled.\n");
 	} else if (!netdev_mc_empty(ndev)) {
 		struct netdev_hw_addr *ha;
 
@@ -481,7 +480,6 @@ static void axienet_set_multicast_list(struct net_device *ndev)
 		reg &= ~XAE_FMI_PM_MASK;
 
 		axienet_iow(lp, XAE_FMI_OFFSET, reg);
-		dev_info(&ndev->dev, "Promiscuous mode disabled.\n");
 	}
 
 	for (; i < XAE_MULTICAST_CAM_TABLE_NUM; i++) {
-- 
2.35.1.1320.gc452695387.dirty