Re: [PATCH v4 1/1] dt-bindings: extcon: ptn5150: add child node port
From: Chanwoo Choi
Date: Thu Aug 22 2024 - 10:35:09 EST
24. 8. 20. 23:39에 Frank Li 이(가) 쓴 글:
> Add child node 'port' to allow connect to usb controller to do role-switch
> if id pin of ptn5150 have not connected to chip's usb ID function pin.
>
> Fix below warning:
> arch/arm64/boot/dts/freescale/imx8mn-var-som-symphony.dtb: typec@3d: 'port' does not match any of the regexes: 'pinctrl-[0-9]+'
> from schema $id: http://devicetree.org/schemas/extcon/extcon-ptn5150.yaml
>
> Signed-off-by: Frank Li <Frank.Li@xxxxxxx>
> ---
> Change from v3 to v4
> - remove extra empty line
> - fix Indentation in example
> Change from v2 to v3
> - only add port to existed example.
> Change from v1 to v2
> - add example for id pin have not connect to main chip's id example.
> - commit 095b96b2b fix "port" warning, but add new warning "connector" is
> not exist. And follow commit revert this change.
> 690085d866f08 Revert "arm64: dts: imx8mn-var-som-symphony: Describe the USB-C connector
> - I have not board in hand to debug why "connector" is not work.
> ---
> .../devicetree/bindings/extcon/extcon-ptn5150.yaml | 11 +++++++++++
> 1 file changed, 11 insertions(+)
>
> diff --git a/Documentation/devicetree/bindings/extcon/extcon-ptn5150.yaml b/Documentation/devicetree/bindings/extcon/extcon-ptn5150.yaml
> index d5cfa32ea52dd..072b3c0c5fd03 100644
> --- a/Documentation/devicetree/bindings/extcon/extcon-ptn5150.yaml
> +++ b/Documentation/devicetree/bindings/extcon/extcon-ptn5150.yaml
> @@ -37,6 +37,11 @@ properties:
> GPIO pin (output) used to control VBUS. If skipped, no such control
> takes place.
>
> + port:
> + $ref: /schemas/graph.yaml#/properties/port
> + description:
> + A port node to link the usb controller for the dual role switch.
> +
> required:
> - compatible
> - interrupts
> @@ -58,5 +63,11 @@ examples:
> interrupt-parent = <&msmgpio>;
> interrupts = <78 IRQ_TYPE_LEVEL_HIGH>;
> vbus-gpios = <&msmgpio 148 GPIO_ACTIVE_HIGH>;
> +
> + port {
> + endpoint {
> + remote-endpoint = <&usb1_drd_sw>;
> + };
> + };
> };
> };
Applied it. Thanks.
--
Best Regards,
Samsung Electronics
Chanwoo Choi