Re: [PATCH v3 3/7] iio: pressure: bmp280: Remove config error check for IIR filter updates
From: Vasileios Amoiridis
Date: Sat Aug 24 2024 - 07:18:24 EST
On Fri, Aug 23, 2024 at 10:15:29PM +0300, Andy Shevchenko wrote:
> On Fri, Aug 23, 2024 at 08:17:10PM +0200, Vasileios Amoiridis wrote:
> > When there is a change in the configuration of the BMP3xx device, several
> > steps take place. These steps include:
> >
> > 1) Update the OSR settings and check if there was an update
> > 2) Update the ODR settings and check if there was an update
> > 3) Update the IIR settings and check if there was an update
> > 4) Check if there was an update with the following procedure:
> > a) Set sensor to SLEEP mode and after to NORMAL mode to trigger
> > a new measurement.
> > b) Wait the maximum amount possible depending on the OSR settings
> > c) Check the configuration error register if there was an error
> > during the configuration of the sensor.
> >
> > This check is necessary, because there could be a case where the OSR is
> > too high for the requested ODR so either the ODR needs to be slower or the
> > OSR needs to be less. This is something that is checked internally by the
> > sensor when it runs in NORMAL mode.
> >
> > In the BMP58x devices the previous steps are done internally by the sensor.
> >
> > The IIR filter settings do not depend on the OSR or ODR settings, and there
> > is no need to run a check in case they change.
>
> ...
>
> > + ret = regmap_update_bits(data->regmap, BMP580_REG_DSP_IIR,
> > + BMP580_DSP_IIR_PRESS_MASK |
> > + BMP580_DSP_IIR_TEMP_MASK, reg_val);
>
> Better to split on logical bounds
>
> ret = regmap_update_bits(data->regmap, BMP580_REG_DSP_IIR,
> BMP580_DSP_IIR_PRESS_MASK | BMP580_DSP_IIR_TEMP_MASK,
> reg_val);
>
> --
> With Best Regards,
> Andy Shevchenko
>
>
This goes beyond the 80 char limit. I know that there is the relaxed
limit of 100 chars but I didn't feel it was more readable like this.
I could definitely use it though, thanks!
Cheers,
Vasilis