Re: [PATCH v1] bus: qcom: Simplify with dev_err_probe()
From: Krzysztof Kozlowski
Date: Fri Aug 30 2024 - 04:09:41 EST
On 29/08/2024 14:41, Yu Jiaoliang wrote:
> Error handling in probe() can be a bit simpler with dev_err_probe().
>
> Signed-off-by: Yu Jiaoliang <yujiaoliang@xxxxxxxx>
> ---
> drivers/bus/qcom-ebi2.c | 6 ++----
> 1 file changed, 2 insertions(+), 4 deletions(-)
>
> diff --git a/drivers/bus/qcom-ebi2.c b/drivers/bus/qcom-ebi2.c
> index c1fef1b4bd89..dbd6a99bcc99 100644
> --- a/drivers/bus/qcom-ebi2.c
> +++ b/drivers/bus/qcom-ebi2.c
> @@ -308,10 +308,8 @@ static int qcom_ebi2_probe(struct platform_device *pdev)
> return PTR_ERR(ebi2xclk);
>
> ret = clk_prepare_enable(ebi2xclk);
> - if (ret) {
> - dev_err(dev, "could not enable EBI2X clk (%d)\n", ret);
> - return ret;
> - }
> + if (ret)
> + return dev_err_probe(dev, ret, "could not enable EBI2X clk\n");
>
> ebi2clk = devm_clk_get(dev, "ebi2");
> if (IS_ERR(ebi2clk)) {
This cannot defer, so not much benefits. And again you change only one
place.
That's pointless and churn.
Best regards,
Krzysztof