[PATCH v2] net: alacritech: Partially revert "net: alacritech: Switch to use dev_err_probe()"

[Krzysztof Kozlowski]

This reverts commit bf4d87f884fe8a4b6b61fe4d0e05f293d08df61c because it
introduced dev_err_probe() in non-probe path, which is not desired.

In general, calling dev_err_probe() after successful probe in case of
handling -EPROBE_DEFER error, will set deferred status on the device
already probed.  This is however not a problem here now, because
dev_err_probe() in affected places is used for handling errors from
request_firmware(), which does not return -EPROBE_DEFER.  Still usage of
dev_err_probe() in such case is not correct, because request_firmware()
could once return -EPROBE_DEFER.

Fixes: bf4d87f884fe ("net: alacritech: Switch to use dev_err_probe()")
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>

---

Changes in v2:
1. Update commit msg (Simon).
---
 drivers/net/ethernet/alacritech/slicoss.c | 13 ++++++++-----
 1 file changed, 8 insertions(+), 5 deletions(-)

diff --git a/drivers/net/ethernet/alacritech/slicoss.c b/drivers/net/ethernet/alacritech/slicoss.c
index 7f0c07c20be3..f62851708d4f 100644
--- a/drivers/net/ethernet/alacritech/slicoss.c
+++ b/drivers/net/ethernet/alacritech/slicoss.c
@@ -1051,9 +1051,11 @@ static int slic_load_rcvseq_firmware(struct slic_device *sdev)
 	file = (sdev->model == SLIC_MODEL_OASIS) ?  SLIC_RCV_FIRMWARE_OASIS :
 						    SLIC_RCV_FIRMWARE_MOJAVE;
 	err = request_firmware(&fw, file, &sdev->pdev->dev);
-	if (err)
-		return dev_err_probe(&sdev->pdev->dev, err,
+	if (err) {
+		dev_err(&sdev->pdev->dev,
 			"failed to load receive sequencer firmware %s\n", file);
+		return err;
+	}
 	/* Do an initial sanity check concerning firmware size now. A further
 	 * check follows below.
 	 */
@@ -1124,9 +1126,10 @@ static int slic_load_firmware(struct slic_device *sdev)
 	file = (sdev->model == SLIC_MODEL_OASIS) ?  SLIC_FIRMWARE_OASIS :
 						    SLIC_FIRMWARE_MOJAVE;
 	err = request_firmware(&fw, file, &sdev->pdev->dev);
-	if (err)
-		return dev_err_probe(&sdev->pdev->dev, err,
-				"failed to load firmware %s\n", file);
+	if (err) {
+		dev_err(&sdev->pdev->dev, "failed to load firmware %s\n", file);
+		return err;
+	}
 	/* Do an initial sanity check concerning firmware size now. A further
 	 * check follows below.
 	 */
-- 
2.43.0