Re: [PATCH v2] usb: typec: tcpci: support edge irq

[Heikki Krogerus]

On Thu, Sep 05, 2024 at 08:53:28AM +0200, Parth Pancholi wrote:
> From: Emanuele Ghidoli <emanuele.ghidoli@xxxxxxxxxxx>
> 
> TCPCI USB PHY - PTN5110 could be used with SOCs that only support
> the edge-triggered GPIO interrupts such as TI's K3 device AM69.
> Move the interrupt configuration to the firmware which would
> allow to accommodate edge triggered interrupts for such SOCs.
> In order to support the edge interrupts, register irq line in advance
> and keep track of occurrence during port registering.
> 
> When the edge interrupts are used, it is observed that some of the
> interrupts are missed when tcpci_irq() is serving the current
> interrupt. Therefore, check the status register at the end of
> tcpci_irq() and re-run the function if the status is not clear
> i.e. pending interrupt.
> 
> Signed-off-by: Emanuele Ghidoli <emanuele.ghidoli@xxxxxxxxxxx>
> Signed-off-by: Parth Pancholi <parth.pancholi@xxxxxxxxxxx>

Reviewed-by: Heikki Krogerus <heikki.krogerus@xxxxxxxxxxxxxxx>

> ---
> v2: Re-enable irq irrespective of tcpci_register_port() return status which was disabled before this call
> ---
>  drivers/usb/typec/tcpm/tcpci.c | 30 ++++++++++++++++++++----------
>  1 file changed, 20 insertions(+), 10 deletions(-)
> 
> diff --git a/drivers/usb/typec/tcpm/tcpci.c b/drivers/usb/typec/tcpm/tcpci.c
> index a2651a2a7f2e..ed32583829be 100644
> --- a/drivers/usb/typec/tcpm/tcpci.c
> +++ b/drivers/usb/typec/tcpm/tcpci.c
> @@ -707,10 +707,13 @@ irqreturn_t tcpci_irq(struct tcpci *tcpci)
>  {
>  	u16 status;
>  	int ret;
> +	int irq_ret;
>  	unsigned int raw;
>  
>  	tcpci_read16(tcpci, TCPC_ALERT, &status);
> +	irq_ret = status & tcpci->alert_mask;
>  
> +process_status:
>  	/*
>  	 * Clear alert status for everything except RX_STATUS, which shouldn't
>  	 * be cleared until we have successfully retrieved message.
> @@ -783,7 +786,12 @@ irqreturn_t tcpci_irq(struct tcpci *tcpci)
>  	else if (status & TCPC_ALERT_TX_FAILED)
>  		tcpm_pd_transmit_complete(tcpci->port, TCPC_TX_FAILED);
>  
> -	return IRQ_RETVAL(status & tcpci->alert_mask);
> +	tcpci_read16(tcpci, TCPC_ALERT, &status);
> +
> +	if (status & tcpci->alert_mask)
> +		goto process_status;
> +
> +	return IRQ_RETVAL(irq_ret);
>  }
>  EXPORT_SYMBOL_GPL(tcpci_irq);
>  
> @@ -915,20 +923,22 @@ static int tcpci_probe(struct i2c_client *client)
>  
>  	chip->data.set_orientation = err;
>  
> -	chip->tcpci = tcpci_register_port(&client->dev, &chip->data);
> -	if (IS_ERR(chip->tcpci))
> -		return PTR_ERR(chip->tcpci);
> -
>  	err = devm_request_threaded_irq(&client->dev, client->irq, NULL,
>  					_tcpci_irq,
> -					IRQF_SHARED | IRQF_ONESHOT | IRQF_TRIGGER_LOW,
> +					IRQF_SHARED | IRQF_ONESHOT,
>  					dev_name(&client->dev), chip);
> -	if (err < 0) {
> -		tcpci_unregister_port(chip->tcpci);
> +	if (err < 0)
>  		return err;
> -	}
>  
> -	return 0;
> +	/*
> +	 * Disable irq while registering port. If irq is configured as an edge
> +	 * irq this allow to keep track and process the irq as soon as it is enabled.
> +	 */
> +	disable_irq(client->irq);
> +	chip->tcpci = tcpci_register_port(&client->dev, &chip->data);
> +	enable_irq(client->irq);
> +
> +	return PTR_ERR_OR_ZERO(chip->tcpci);
>  }
>  
>  static void tcpci_remove(struct i2c_client *client)
> -- 
> 2.34.1

-- 
heikki