Re: [PATCH v2 0/2] iio: temperature: tmp006: support for drdy irq

[Jonathan Cameron]

On Sun,  8 Sep 2024 19:21:51 +0200
Antoni Pokusinski <apokusinski01@xxxxxxxxx> wrote:

> This patch series adds support for the data ready interrupt of tmp006
> sensor. The interrupt line is pulled down once there is a measurement
> available to be read. Hence, triggered buffers are used in order to
> support continuous data capture for the sensor.
> 
Applied to the testing branch of iio.git.
I'll rebase that on rc1 once available and push this out as togreg
at which point linux-next will pick it up etc.

Thanks,

Jonathan

> Changes since v1:
>   * dt-binding: improve the commit message
>   * tmp006_read_raw: use iio_device_claim_direct_scoped()
>   * tmp006_channels[] : add trailing commas
>   * tmp006_trigger_handler: use s32 to check return value of read_word_data()
>   * tmp006_set_trigger_state: fix data alignment
>   * tmp006_probe: check return value of devm_iio_triggered_buffer_setup()
>   * tmp006_probe: remove IRQF_TRIGGER_FALLING from irqflags argument of
>     devm_request_threaded_irq()
>   * tmp006_probe: set avaliable_scan_masks to tmp006_scan_masks[]
> 
> Antoni Pokusinski (2):
>   iio: temperature: tmp006: add triggered buffer support
>   dt-bindings: iio: temperature: tmp006: document interrupt
> 
>  .../bindings/iio/temperature/ti,tmp006.yaml   |   6 +
>  drivers/iio/temperature/Kconfig               |   2 +
>  drivers/iio/temperature/tmp006.c              | 134 ++++++++++++++++--
>  3 files changed, 129 insertions(+), 13 deletions(-)
>