Re: [PATCH v2 3/3] dt-bindings: mmc: convert amlogic,meson-mx-sdio.txt to dtschema

[Krzysztof Kozlowski]

On Fri, Sep 20, 2024 at 10:38:05AM +0200, Neil Armstrong wrote:
> Convert the Amlogic Meson6, Meson8 and Meson8b SDIO/MMC controller
> bindings to dt-schema.
> 
> Signed-off-by: Neil Armstrong <neil.armstrong@xxxxxxxxxx>

...

> +properties:
> +  compatible:
> +    items:
> +      - enum:
> +          - amlogic,meson8-sdio
> +          - amlogic,meson8b-sdio
> +      - const: amlogic,meson-mx-sdio
> +
> +  reg:
> +    maxItems: 1
> +
> +  interrupts:
> +    maxItems: 1
> +
> +  clocks:
> +    maxItems: 2
> +
> +  clock-names:
> +    items:
> +      - const: core
> +      - const: clkin
> +
> +  "#address-cells":
> +    const: 1
> +
> +  "#size-cells":
> +    const: 0
> +
> +patternProperties:
> +  "slot@[0-2]+$":

^slot@[0-2]$

(because foo-slot@22 is wrong)


> +    $ref: mmc-slot.yaml#
> +    description:
> +      A node for each slot provided by the MMC controller
> +
> +    properties:
> +      reg:
> +        description:
> +          the slot (or "port") ID

Drop description. Should be rather part of mmc-slot.yaml.

> +        enum: [0, 1, 2]
> +
> +      bus-width:
> +        enum: [1, 4]
> +
> +    unevaluatedProperties: false

Hm, I wonder why not all slots are defined in your DTS? Why not all of
them are required? I assume the slots are there always, as part of the
controller.

Is this because of driver limitation mentioned in the old binding?

> +
> +required:
> +  - compatible
> +  - reg
> +  - interrupts
> +  - clocks
> +  - clock-names
> +  - "#address-cells"
> +  - "#size-cells"
> +
> +additionalProperties: false
> +
> +examples:
> +  - |
> +    #include <dt-bindings/interrupt-controller/irq.h>
> +    #include <dt-bindings/interrupt-controller/arm-gic.h>
> +    mmc@c1108c20 {
> +        compatible = "amlogic,meson8-sdio", "amlogic,meson-mx-sdio";
> +        reg = <0xc1108c20 0x20>;
> +        interrupts = <GIC_SPI 28 IRQ_TYPE_EDGE_RISING>;
> +        clocks = <&clk_core>, <&clk_in>;
> +        clock-names = "core", "clkin";
> +        #address-cells = <1>;
> +        #size-cells = <0>;
> +
> +        slot@1 {
> +            compatible = "mmc-slot";
> +            reg = <1>;
> +            bus-width = <4>;

Best regards,
Krzysztof