[PATCH 0/2] Compute HS HCNT and LCNT based on HW parameters

[Michael Wu]

In commit 35eba185fd1a ("i2c: designware: Calculate SCL timing
parameters for High Speed Mode") hs_hcnt and hs_lcnt are computed based
on fixed tHIGH = 160 and tLOW = 320. However, this fixed values only
applies to the combination of hardware parameters "IC_CAP_LOADING = 400pF"
and "IC_FREQ_OPTIMIZATION = 1". Outside of this combination, SCL frequency
may not reach 3.4 MHz if hs_hcnt and hs_lcnt are both computed using these
two fixed values.

Since there are no any registers controlling these two hardware
parameters, their values ​​can only be noted through the device tree.

Michael Wu (2):
  i2c: designware: determine HS tHIGH and tLOW based on HW paramters
  dt-bindings: i2c: snps,designware-i2c: add bus-loading and
    clk-freq-optimized

 .../bindings/i2c/snps,designware-i2c.yaml     | 19 +++++++++++++++
 drivers/i2c/busses/i2c-designware-common.c    | 16 +++++++++++++
 drivers/i2c/busses/i2c-designware-core.h      |  8 +++++++
 drivers/i2c/busses/i2c-designware-master.c    | 24 +++++++++++++++++--
 drivers/i2c/busses/i2c-designware-platdrv.c   |  2 ++
 5 files changed, 67 insertions(+), 2 deletions(-)

-- 
2.43.0