Re: [PATCH v3 06/27] x86/cea: Export per CPU variable cea_exception_stacks

[Xin Li]

On 10/1/2024 9:12 AM, Dave Hansen wrote:
> On 9/30/24 22:00, Xin Li (Intel) wrote:
> > The per CPU variable cea_exception_stacks contains per CPU stacks for
> > NMI, #DB and #DF, which is referenced in KVM to set host FRED RSP[123]
> > each time a vCPU is loaded onto a CPU, thus it needs to be exported.
>
> Nit: It's not obvious how 'cea_exception_stacks' get used in this
> series.  It's never referenced explicitly.
>
> I did figure it out by looking for 'RSP[123]' references, but a much
> better changelog would be something like:
>
> 	The per CPU array 'cea_exception_stacks' points to per CPU
> 	stacks for NMI, #DB and #DF. It is normally referenced via the
> 	#define: __this_cpu_ist_top_va().
>
> 	FRED introduced new fields in the host-state area of the VMCS
> 	for stack levels 1->3 (HOST_IA32_FRED_RSP[123]). KVM must
> 	populate these each time a vCPU is loaded onto a CPU.

Yeah, this is way clearer.

> See how that explicitly gives the reader greppable strings for
> "__this_cpu_ist_top_va" and "HOST_IA32_FRED_RSP"?  That makes it much
> easier to figure out what is going on.

Nice for a maintainer in 20 years :)

> I was also momentarily confused about why these loads need to be done on
> _every_ vCPU load.  I think it's because the host state can change as
> the vCPU moves around to different physical CPUs and
> __this_cpu_ist_top_va() can and will change.  But it's a detail that I
> think deserves to be explained in the changelog.  There is also this
> note in vmx_vcpu_load_vmcs():

Makes sense to me.

> >                  /*
> >                   * Linux uses per-cpu TSS and GDT, so set these when switching
> >                   * processors.  See 22.2.4.
> >                   */
>
> which makes me think that it might not be bad to pull *all* of the
> per-cpu VMCS field population code out into a helper since the reasoning
> of why these need to be repopulated is identical.
>
> Also, what's the purpose of clearing GUEST_IA32_FRED_RSP[123] at
> init_vmcs() time?  I would have thought that those values wouldn't
> matter until the VMCS gets loaded at vmx_vcpu_load_vmcs() when they are
> overwritten anyway.  Or, I could be just totally misunderstanding how
> KVM consumes the VMCS. :)

I don't see any misunderstanding.  However we just do what the SDM
claims, even it seems that it's not a must *logically*.

FRED spec says:
The RESET state of each of the new MSRs is zero. INIT does not change
the value of the new MSRs

Thanks!
    Xin