Re: [PATCH 0/4] ARM: dts: omap: omap4-epson-embt2ws: misc gpio definitions

[Rob Herring (Arm)]

On Mon, 30 Sep 2024 23:30:04 +0200, Andreas Kemnade wrote:
> Bring the system into a more defined state and do not rely
> on things being initialized by bootloader.
> 
> Andreas Kemnade (4):
>   ARM: dts: omap: omap4-epson-embt2ws: define GPIO regulators
>   ARM: dts: omap: omap4-epson-embt2ws: wire up regulators
>   ARM: dts: omap: omap4-epson-embt2ws: add unknown gpio outputs
>   ARM: dts: omap: omap4-epson-embt2ws: add GPIO expander
> 
>  .../boot/dts/ti/omap/omap4-epson-embt2ws.dts  | 175 +++++++++++++++++-
>  1 file changed, 171 insertions(+), 4 deletions(-)
> 
> --
> 2.39.5
> 
> 
> 


My bot found new DTB warnings on the .dts files added or changed in this
series.

Some warnings may be from an existing SoC .dtsi. Or perhaps the warnings
are fixed by another series. Ultimately, it is up to the platform
maintainer whether these warnings are acceptable or not. No need to reply
unless the platform maintainer has comments.

If you already ran DT checks and didn't see these error(s), then
make sure dt-schema is up to date:

  pip3 install dtschema --upgrade


New warnings running 'make CHECK_DTBS=y ti/omap/omap4-epson-embt2ws.dtb' for 20240930213008.159647-1-andreas@xxxxxxxxxxxx:

arch/arm/boot/dts/ti/omap/omap4-epson-embt2ws.dtb: serial@0: {'compatible': ['ti,omap4-uart'], 'reg': [[0, 256]], 'interrupts': [[0, 74, 4]], 'clock-frequency': 48000000, 'pinctrl-names': ['default'], 'pinctrl-0': [[115]], 'interrupts-extended': [[1, 0, 74, 4], [116, 260]], '$nodename': ['serial@0']} is valid under each of {'required': ['interrupts-extended']}, {'required': ['interrupts']}
	from schema $id: http://devicetree.org/schemas/serial/8250_omap.yaml#
arch/arm/boot/dts/ti/omap/omap4-epson-embt2ws.dtb: serial@0: {'compatible': ['ti,omap4-uart'], 'reg': [[0, 256]], 'interrupts': [[0, 73, 4]], 'clock-frequency': 48000000, 'pinctrl-names': ['default'], 'pinctrl-0': [[118, 119]], 'interrupts-extended': [[1, 0, 73, 4], [116, 220]], 'bluetooth-gnss': {'compatible': ['ti,wl1283-st'], 'enable-gpios': [[120, 25, 0]], 'clocks': [[121, 1]], 'clock-names': ['ext_clock']}, '$nodename': ['serial@0']} is valid under each of {'required': ['interrupts-extended']}, {'required': ['interrupts']}
	from schema $id: http://devicetree.org/schemas/serial/8250_omap.yaml#