Re: [PATCH 01/11] dt-bindings: dma: stm32-dma3: prevent packing/unpacking mode

[Rob Herring (Arm)]

On Thu, 10 Oct 2024 16:27:51 +0200, Amelie Delaunay wrote:
> When source data width/burst and destination data width/burst are
> different, data are packed or unpacked in DMA3 channel FIFO.
> Data are pushed out from DMA3 channel FIFO when the destination burst
> length (= data width * burst) is reached.
> If the channel is stopped before the transfer end, and if some bytes are
> packed/unpacked in the DMA3 channel FIFO, these bytes are lost.
> Indeed, DMA3 channel FIFO has no flush capability, only reset.
> To avoid potential bytes lost, pack/unpack must be prevented by setting
> memory data width/burst equal to peripheral data width/burst.
> Memory accesses will be penalized. But it is the only way to avoid bytes
> lost.
> 
> Some devices (e.g. cyclic RX like UART) need this, so add the possibility
> to prevent pack/unpack feature, by setting bit 16 of the 'DMA transfer
> requirements' bit mask.
> 
> Signed-off-by: Amelie Delaunay <amelie.delaunay@xxxxxxxxxxx>
> ---
>  Documentation/devicetree/bindings/dma/stm32/st,stm32-dma3.yaml | 3 +++
>  1 file changed, 3 insertions(+)
> 

Acked-by: Rob Herring (Arm) <robh@xxxxxxxxxx>