Re: [PATCH v2 4/5] clk: qcom: dispcc-qcm2290: remove alpha values from disp_cc_pll0_config

From: Dmitry Baryshkov
Date: Mon Oct 28 2024 - 17:32:23 EST


On Mon, Oct 28, 2024 at 07:48:18PM +0100, Gabor Juhos wrote:
> Since both the 'alpha' and 'alpha_hi' members of the configuration is
> initialized (the latter is implicitly) with zero values, the output
> rate of the PLL will be the same whether alpha mode is enabled or not.
>
> Remove the initialization of the alpha* members to make it clear that
> the alpha mode is not required to get the desired output rate.
>
> Despite that enabling alpha mode is not needed for the initial
> configuration, the set_rate() op might require that it is enabled
> already. In this particular case however, the clk_alpha_pll_set_rate()
> function will get reset the ALPHA_EN bit when the PLL's rate changes,
> so dropping 'alpha_en_mask' is safe.
>
> No functional changes intended, compile tested only.
>
> Signed-off-by: Gabor Juhos <j4g8y7@xxxxxxxxx>
> ---
> Changes in v2:
> - extend the commit message to indicate that dropping 'alpha_en_mask' is safe
> - Link to v1: https://lore.kernel.org/r/20241021-alpha-mode-cleanup-v1-4-55df8ed73645@xxxxxxxxx
> ---
> drivers/clk/qcom/dispcc-qcm2290.c | 2 --
> 1 file changed, 2 deletions(-)
>

Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>

--
With best wishes
Dmitry