Re: [PATCH] dt-bindings: mfd: bd71828: Use charger resistor in mOhm instead of MOhm

[Matti Vaittinen]

On 01/11/2024 21:27, Rob Herring wrote:
> On Tue, Oct 29, 2024 at 12:11:12PM +0100, Andreas Kemnade wrote:
> > Apparently there was some confusion regarding milliohm vs. megaohm.
> > (m/M). Use microohms to be able to properly specify the charger
> > resistor like other drivers do. This is not used yet by mainline code
> > yet. Specify a current sense resistor in milliohms range rathes then
> > megaohms range in the examples.
>
> milliohms?
>
> rathes?
>
> > CC: sre@xxxxxxxxxx
> > Reported-by: Matti Vaittinen <mazziesaccount@xxxxxxxxx>
> > Closes: https://lore.kernel.org/imx/6dcd724a-a55c-4cba-a45b-21e76b1973b0@xxxxxxxxx/T/#mf590875a9f4d3955cd1041d7196ff0c65c0a7e9d
> > Signed-off-by: Andreas Kemnade <andreas@xxxxxxxxxxxx>
> > ---
> >   .../devicetree/bindings/mfd/rohm,bd71828-pmic.yaml  | 13 +++++++------
> >   1 file changed, 7 insertions(+), 6 deletions(-)
>
> Looks like rohm,bd71815-pmic.yaml has the same problem.

Yes! Thanks for pointing it out. I'll wait for a while if Andreas wants 
to fix them both at the same go. I'll send a fix for BD71815 if I've not 
seen one in a week or so :)

Yours,
    --Matti