Re: [PATCH v6 7/7] arm64: dts: qcom: ipq5424: Add thermal zone nodes

[Konrad Dybcio]

On 6.11.2024 11:25 AM, Manikanta Mylavarapu wrote:
> 
> 
> On 11/6/2024 2:42 PM, Konrad Dybcio wrote:
>>
>>
>> On 11/6/24 09:47, Manikanta Mylavarapu wrote:
>>>
>>>
>>> On 11/4/2024 7:21 PM, Konrad Dybcio wrote:
>>>> On 4.11.2024 1:44 PM, Manikanta Mylavarapu wrote:
>>>>> Add thermal zone nodes for sensors present in IPQ5424.
>>>>>
>>>>> Signed-off-by: Manikanta Mylavarapu <quic_mmanikan@xxxxxxxxxxx>
>>>>> ---
>>>> [...]
>>>>
>>>>> +
>>>>> +        cpu3-thermal {
>>>>> +            polling-delay-passive = <0>;
>>>>> +            polling-delay = <0>;
>>>>> +            thermal-sensors = <&tsens 13>;
>>>>> +
>>>>> +            trips {
>>>>> +                cpu-critical {
>>>>> +                    temperature = <120000>;
>>>>> +                    hysteresis = <9000>;
>>>>> +                    type = "critical";
>>>>> +                };
>>>>> +
>>>>> +                cpu-passive {
>>>>> +                    temperature = <110000>;
>>>>> +                    hysteresis = <9000>;
>>>>> +                    type = "passive";
>>>>
>>>> You have a passive trip point without passive polling
>>>>
>>>
>>> Okay, will remove this.
>>
>> You most likely want to preserve it, while keeping a sensible
>> polling frequency, so that userspace will be aware of the current
>> CPU temperature. <100> sounds like a sensible value here.
>>
>> Konrad
> 
> Temperature sensor's present in IPQ5424 supports interrupts.

Correct.

> Hence no need to configure polling frequency.

No, that interrupt firing signifies crossing the temp threshold (meaning
no updates beyond that) or the tsens watchdog barking.

Konrad