Re: [PATCH 3/3] can: flexcan: handle S32G2/S32G3 separate interrupt lines

[Ciprian Marian Costea]

On 11/20/2024 12:54 PM, Marc Kleine-Budde wrote:
> On 20.11.2024 12:47:02, Ciprian Marian Costea wrote:
> > > > > > The mainline driver already handles the 2nd mailbox range (same
> > > > > > 'flexcan_irq') is used. The only difference is that for the 2nd mailbox
> > > > > > range a separate interrupt line is used.
> > > > >
> > > > > AFAICS the IP core supports up to 128 mailboxes, though the driver only
> > > > > supports 64 mailboxes. Which mailboxes do you mean by the "2nd mailbox
> > > > > range"? What about mailboxes 64..127, which IRQ will them?
> > > >
> > > > On S32G the following is the mapping between FlexCAN IRQs and mailboxes:
> > > > - IRQ line X -> Mailboxes 0-7
> > > > - IRQ line Y -> Mailboxes 8-127 (Logical OR of Message Buffer Interrupt
> > > > lines 127 to 8)
> > > >
> > > > By 2nd range, I was refering to Mailboxes 8-127.
> > >
> > > Interesting, do you know why it's not symmetrical (0...63, 64...127)?
> > > Can you point me to the documentation.
> >
> > Unfortunately I do not know why such hardware integration decisions have
> > been made.
> >
> > Documentation for S32G3 SoC can be found on the official NXP website,
> > here:
> > https://www.nxp.com/products/processors-and-microcontrollers/s32-automotive-platform/s32g-vehicle-network-processors/s32g3-processors-for-vehicle-networking:S32G3
> >
> > But please note that you need to setup an account beforehand.
>
> I have that already, where is the mailbox to IRQ mapping described?
>
> regards,
> Marc

If you have successfully downloaded the Reference Manual for S32G2 or 
S32G3 SoC, it should have attached an excel file describing all the 
interrupt mappings.

In the excel file, if you search for 'FlexCAN_0' for example, you should 
be able to find IRQ lines 39 and 40 which correspond to Maiboxes 0-7 and 
8-129 (ored) previously discussed.

Best Regards,
Ciprian