[PATCH v1 3/7] dt-bindings: serial: Document DT properties for QUP firmware loading

[Viken Dadhaniya]

Document the 'qcom,load-firmware' and 'qcom,xfer-mode' properties to
support SE(Serial Engine) firmware loading from the protocol driver and to
select the data transfer mode, either GPI DMA (Generic Packet Interface)
or non-GPI mode (PIO/CPU DMA).

UART controller can operate in one of two modes based on the
'qcom,xfer-mode' property, and the firmware is loaded accordingly.

Co-developed-by: Mukesh Kumar Savaliya <quic_msavaliy@xxxxxxxxxxx>
Signed-off-by: Mukesh Kumar Savaliya <quic_msavaliy@xxxxxxxxxxx>
Signed-off-by: Viken Dadhaniya <quic_vdadhani@xxxxxxxxxxx>
---
 .../bindings/serial/qcom,serial-geni-qcom.yaml       | 12 ++++++++++++
 1 file changed, 12 insertions(+)

diff --git a/Documentation/devicetree/bindings/serial/qcom,serial-geni-qcom.yaml b/Documentation/devicetree/bindings/serial/qcom,serial-geni-qcom.yaml
index dd33794b3534..21a5b0dafbe0 100644
--- a/Documentation/devicetree/bindings/serial/qcom,serial-geni-qcom.yaml
+++ b/Documentation/devicetree/bindings/serial/qcom,serial-geni-qcom.yaml
@@ -56,6 +56,16 @@ properties:
   reg:
     maxItems: 1
 
+  qcom,load-firmware:
+    type: boolean
+    description: Optional property to load SE (serial engine) Firmware from protocol driver.
+
+  qcom,xfer-mode:
+    description: Value 1,2 and 3 represents FIFO, CPU DMA and GSI DMA mode respectively.
+    $ref: /schemas/types.yaml#/definitions/uint32
+    enum: [1, 2, 3]
+
+
 required:
   - compatible
   - clocks
@@ -82,5 +92,7 @@ examples:
         interconnects = <&qup_virt MASTER_QUP_CORE_0 0 &qup_virt SLAVE_QUP_CORE_0 0>,
                         <&gem_noc MASTER_APPSS_PROC 0 &config_noc SLAVE_QUP_0 0>;
         interconnect-names = "qup-core", "qup-config";
+        qcom,load-firmware;
+        qcom,xfer-mode = <1>;
     };
 ...
-- 
2.34.1