Re: [PATCH v3] arm64: dts: qcom: qcs615: add WiFi/BT nodes

[Yu Zhang (Yuriy)]

On 12/6/2024 8:16 PM, Konrad Dybcio wrote:
> On 6.12.2024 4:22 AM, Yu Zhang (Yuriy) wrote:
> > On 12/6/2024 1:14 AM, Konrad Dybcio wrote:
> > > On 3.12.2024 7:03 AM, Yu Zhang(Yuriy) wrote:
> > > > Add a node for the PMU module of the WCN6855 present on the qcs615
> > > > board. Assign its LDO power outputs to the existing WiFi/BT module.
> > >
> > > subject:
> > >
> > > arm64: dts: qcom: qcs615-ride: ....
> > >
> > > [...]
> > >
> > > > +
> > > > +    vreg_conn_1p8: vreg_conn_1p8 {
> > > > +        compatible = "regulator-fixed";
> > > > +        regulator-name = "vreg_conn_1p8";
> > > > +        startup-delay-us = <4000>;
> > > > +        enable-active-high;
> > > > +        gpio = <&pm8150_gpios 1 GPIO_ACTIVE_HIGH>;
> > > > +    };
> > > > +
> > > > +    vreg_conn_pa: vreg_conn_pa {
> > > > +        compatible = "regulator-fixed";
> > > > +        regulator-name = "vreg_conn_pa";
> > > > +        startup-delay-us = <4000>;
> > > > +        enable-active-high;
> > > > +        gpio = <&pm8150_gpios 6 GPIO_ACTIVE_HIGH>;
> > > > +    };
> > >
> > > Are any of these boot-on?
> > Yes, these are used wcn6855-pmu：
> >       vddio-supply = <&vreg_conn_pa>;
> >       vddpmu-supply = <&vreg_conn_1p8>;
>
> What i meant is, whether these regulators are enabled at boot
> time (i.e. without software intervention). If that's the case,
> `regulator-boot-on;` should be added
No need regulator-boot-on, it was triggered by the 
software(pci_pwrctl_pwrseq_driver).
> Konrad
Yu