[PATCH v4 18/24] ASoC: dt-bindings: renesas,rz-ssi: Remove DMA description

[Claudiu]

From: Claudiu Beznea <claudiu.beznea.uj@xxxxxxxxxxxxxx>

Remove the DMA description, as it duplicates content from
../dma/renesas,rz-dma.yaml. Additionally, remove the MID/RID examples
mentioned in the dropped description (this information is already
documented in the hardware manual).

Suggested-by: Geert Uytterhoeven <geert@xxxxxxxxxxxxxx>
Signed-off-by: Claudiu Beznea <claudiu.beznea.uj@xxxxxxxxxxxxxx>
---

Changes in v4:
- none; this patch is new

 .../bindings/sound/renesas,rz-ssi.yaml         | 18 ------------------
 1 file changed, 18 deletions(-)

diff --git a/Documentation/devicetree/bindings/sound/renesas,rz-ssi.yaml b/Documentation/devicetree/bindings/sound/renesas,rz-ssi.yaml
index f4610eaed1e1..5b42eec864f8 100644
--- a/Documentation/devicetree/bindings/sound/renesas,rz-ssi.yaml
+++ b/Documentation/devicetree/bindings/sound/renesas,rz-ssi.yaml
@@ -57,24 +57,6 @@ properties:
   dmas:
     minItems: 1
     maxItems: 2
-    description:
-      The first cell represents a phandle to dmac.
-      The second cell specifies the encoded MID/RID values of the SSI port
-      connected to the DMA client and the slave channel configuration
-      parameters.
-      bits[0:9]   - Specifies MID/RID value of a SSI channel as below
-                    MID/RID value of SSI rx0 = 0x256
-                    MID/RID value of SSI tx0 = 0x255
-                    MID/RID value of SSI rx1 = 0x25a
-                    MID/RID value of SSI tx1 = 0x259
-                    MID/RID value of SSI rt2 = 0x25f
-                    MID/RID value of SSI rx3 = 0x262
-                    MID/RID value of SSI tx3 = 0x261
-      bit[10]     - HIEN = 1, Detects a request in response to the rising edge
-                    of the signal
-      bit[11]     - LVL = 0, Detects based on the edge
-      bits[12:14] - AM = 2, Bus cycle mode
-      bit[15]     - TM = 0, Single transfer mode
 
   dma-names:
     oneOf:
-- 
2.39.2