Re: [PATCH v6] i2c: imx-lpi2c: add target mode support

[Andi Shyti]

Hi Carlos,

On Fri, Dec 27, 2024 at 03:28:57PM +0800, Carlos Song wrote:
> LPI2C support master controller and target controller enabled
> simultaneously. Both controllers share the same SDA/SCL lines
> and interrupt source but has a separate control and status
> registers. When target is enabled and an interrupt has been
> triggered, target register status will be checked to determine
> IRQ source. Then enter the corresponding interrupt handler
> function of master or target to handle the interrupt event.
> 
> This patch supports basic target data read/write operations in
> 7-bit target address. LPI2C target mode can be enabled by using
> I2C slave backend. I2C slave backend behaves like a standard I2C
> client. For simple use and test, Linux I2C slave EEPROM backend
> can be used.
> 
> Signed-off-by: Carlos Song <carlos.song@xxxxxxx>

merged to i2c/i2c-host.

Thanks,
Andi